TYPE ACCEPTANCE CERTIFICATES FOR IMPORTED AIRCRAFTCooperative Development of Operational Safety & Continuing AirworthinessCOSCAP

TYPE ACCEPTANCE CERTIFICATES OBJECTIVEThis chapter provides guidance in the procedure for the issue of a Type Acceptance Certificate for foreign aircraft types, using an automatic acceptance procedure.

TYPE ACCEPTANCE CERTIFICATESType Certificate. A TC, as defined by FAR 21.41, includes the type design, the operating limitations, the type certificate data sheet (TCDS), the applicable regulations, and any other conditions or limitations prescribed by the FAA

TYPE ACCEPTANCE CERTIFICATESRecognised countriesRecognised country for the purpose of issuing type certificates is a state(ICAO contracting or not) where the NAA has been found to have a comprehensive code of Airworthiness certification and over sight.

TYPE ACCEPTANCE CERTIFICATES Recognised countriesThe foreign NAA that issued the original Type Certificate will be regarded as the nominated NAA for airworthiness control of the aircraft listed on that certificate.Note: This automatic acceptance procedure must not be applied in situations where the NAA of a recognised country has issued a Type Acceptance Certificate or similar document on the basis that the NAA of another country has issued a Type Certificate.

TYPE ACCEPTANCE CERTIFICATES(a) Transport;(b) Normal;(c) Utility;(d) Acrobatic;

(e) Commuter;(f) Manned free balloons;(g) Primary;(h) RestrictedCertificate of Airworthiness CategoriesType Acceptance Certificates are issued to enable Certificates of Airworthiness (CoAs) to be issued in one or more of the following categories:

TYPE ACCEPTANCE CERTIFICATES Certificate of Airworthiness Categories CoAs should usually be issued in the same category available under the foreign Type Certificate, subject to a review by the Authority of the foreign certification basis, including any special conditions, waivers, exemptions, equivalent safety determinations etc. made by the foreign NAA.

TYPE ACCEPTANCE CERTIFICATESAircraft type detailsThe application should state exactly which models are to be included on the Type Acceptance Certificate. These models must be included on the foreign Type Certificate. Each model included on the Type Acceptance Certificate must be covered by the required data.

TYPE ACCEPTANCE CERTIFICATESSupply of dataThe following data should be supplied: A statement of the applicable design certification standards.General interior arrangement configuration drawingsThree-view drawing exterior configuration.Master drawing listMaster equipment list

TYPE ACCEPTANCE CERTIFICATES Supply of data (Continued)Aircraft Flight Manual including the Configuration Deviation List, if applicable.Instructions for Continued Airworthiness.Certification compliance (checklist)Data and descriptive information needed by the Authority to approve the type certificate data sheet.Listing of service life for critical parts subject to fatigue.

TYPE ACCEPTANCE CERTIFICATESSupply of continuing airworthiness dataType acceptance is conditional on the continued airworthiness support of the aircraft and components in the form of service bulletins and other instructions, amendments to documents, and foreign airworthiness directives etc. The applicant must arrange for the foreign Type Certificate holder to continue to supply this data.

TYPE ACCEPTANCE CERTIFICATESThe Authority should arrange with the nominated NAA for the supply of airworthiness directives issued by that NAA for the type of aircraft concerned.

CONDITIONS, REFUSAL, SUSPENSION OR CANCELLATIONIssue of a Type Acceptance Certificate subject to conditionsThe Authority may issue a Type Acceptance Certificate (TAC) subject to conditions, provided there are reasonable grounds for believing that issuing the certificate without imposing conditions or taking other measures would constitute a significant threat to aviation safety.

TYPE ACCEPTANCE CERTIFICATESCONDITIONS, REFUSAL, SUSPENSION OR CANCELLATION Refusal to issue a Type Acceptance CertificateNote that Authority may, refuse to issue a Type Acceptance Certificate if there are reasonable safety grounds not to do so.

TYPE ACCEPTANCE CERTIFICATESSuspension or cancellation of a TAC. The Authority may suspend or cancel a TAC if it considers that it is necessary to do so in the interests of aviation safety. An inability on the part of the foreign Type Certificate holder to provide ongoing technical support for the aircraft type may constitute grounds for such suspension or cancellation.

TYPE ACCEPTANCE CERTIFICATESConsultationThe Authority should consult with and consider the views of, the applicant, the NAA that issued the foreign Type Certificate, and the manufacturer.

TYPE ACCEPTANCE CERTIFICATESDirector should exercise powers personallyNormally only the Director has the power to:issue a Type Acceptance Certificate subject to a condition,refuse to issue a Type Acceptance Certificate orsuspend or cancel a Type Acceptance Certificate.

AGED TRANSPORT CATEGORY AIRCRAFTThe applicant should be aware that before a standard CoA can be issued to such an aircraft, the Authority may require additional data related to the aircraft history, structural integrity programs, supplementary inspections etc.

TYPE ACCEPTANCE CERTIFICATESTYPE CERTIFICATION COMPLETION CHECKLISTResolution of all technical issues.A statement from the Authority certifying compliance with the type certification basis or agreed certification criteria (including additional technical conditions).Compliance checklist.

TYPE ACCEPTANCE CERTIFICATESCHECK LISTInstructions for Continued Airworthiness or Airworthiness Limitations.Draft Aircraft Flight Manual.Draft Type Certificate Data Sheet.Noise Evaluation Statement (not required for amended TCs). Programme Dates established (end, TCDS follows)

TYPE DATA SHEETSAIRCRAFT SPECIFICATION NO. A-780 - Revision 12 PIPER PA-12 PA-12S August 28, 1995Type Certificate HolderThe New Piper Aircraft, Inc.2926 Piper DriveVero Beach, Florida 32960I - Model PA-12, 3 PCLM (Normal Category), 2 PCLM (Utility Category), Approved March 24, 1947.

TYPE DATA SHEETSEngineLycoming O-235-C (See also Item 103 for optional engine)Fuel 73 minimum octane aviation gasolineEngine Limits - For all operations, 2600 rpm (100 hp.)Airspeed Limits- Maneuvering 94 mph (82 knots TIA) Cruising 110 mph (96 knots) True Ind.Never exceed (Normal)138 mph (120 knots) True Ind. (Utility) 148 mph (129 knots) True Ind.

TYPE DATA SHEETSC.G. Range (+ 9.0) to (+ 18.6)Empty Weight C.G. Range(+ 9.5) to (+ 13.3)When empty weight C.G. falls within this range, computation of critical fore and aft C.G. positions is unnecessary. Range is not valid for non-standard arrangements.Maximum Weight,Normal Category:1750 lbs. Utility Category: 1500 lbs.Number of Seats 3 (One at + 6 and two at + 34)Only one person permitted in rear seat when operating in Utility Category.

TYPE DATA SHEETSMaximum Baggage41 lbs. (+ 56)Fuel Capacity38 gallons (+ 23) (one 19 gallon tank in each wing)Oil Capacity6 quarts (-41)Control Surface Movements Elevator 27Up32DownRudder, 20Left20RightAileron 31Up25DownStabilizer 115'Up530'Down

TYPE DATA SHEETSSerial Nos. Eligible12-1 and up.Required EquipmentLandplane - Items 1(a), 101, 102, 201(a), 202(a) and 401(a).Skiplane - Items 1(a), 101, 102, 203, and 401(b).

II - Model PA-12S, 3 PCSM (Normal Category Only). Approved August 11, 1948.Engine: Lycoming O-235-C (See also Item 103 for optional engine)Fuel80 minimum octane aviation gasolineEngine Limits: For all operations, 2600 rpm, 100hpAirspeed Limits Maneuvering 97 mph (82 kts TIA, Cruising110 mph. (96 knots) True Ind.

TYPE DATA SHEETSNever exceed 138 mph (120 knots) True Ind.C.G. Range (+ 15.2) to (+ 18.2) at 1838 lbs.(+ 9.2) to (+ 18.2) at 1405 lbs. or less, Straight line variation between points given.Empty Weight C.G. Range: (+ 9.5) to (+ 13.3).When empty weight C.G. falls within this range, computation of critical fore and aft C.G. positions is unnecessary. Range is not valid for non-standard arrangements.Maximum Weight1838 lbs.

TYPE DATA SHEETSNumber of Seats 3 (One at + 6 and two at + 34)Maximum Baggage41 lbs. (+ 56)Fuel Capacity38 gallons (+ 23) (One 19 gallon tank in each wing.)Oil Capacity6 quarts (-41)Serial Nos. Eligible12-1 and up.Required Equipment: Items 1(a), 101, 102, 204 and 401(d).

TYPE DATA SHEETSSpecifications Pertinent to All ModelsDatum:Leading edge of wingLeveling Means:Plumb bob from machine screw at door frame channels near upper rear corner of door to hole in plate near rear seat.Certification BasisType Certificate No. 780 (CAR 3)Production Basis: Approved for manufacture of spare parts only under Production Certificate No. 206.Export Eligibility: Deleted as of - August 28, 1995.Equipment A plus (+) or minus (-) sign preceding the weight of an item of equipment indicates net weight change when that item is installed.

Propellers and Propeller AccessoriesPropeller - Sensenich 74FE44, 74FE54, or any other fixed pitch wood propeller which is eligible for the engine power and speed and which meets the following limits:With O-235-C or O-235-C1 engine - landplane and skiplane:Static rpm at max. permissible throttle setting:Not over 2300, not under 1900.No additional tolerance permitted.Diameter: Not over 76 inches, not under 72 inches.(More

Engine and Engine Accessories - Fuel and Oil System101. Carburetor air heater+ 1 lbs. (-35)102. Carburetor air scoop103. Engine - Lycoming O-235-C1No Weight ChangeFuel - 80 minimum octane aviation gasolineEngine limits:Take off 2800 rpm (115 hp)All other operations 2600 rpm (108 hp)

Landing Gear and Floats201.Two main wheel-brake assemblies, 8.00-4, Type III (a) Goodrich model 841, with 8.00-4, 4-Ply rating tires and regular tubes + 31 lbs. (+ 1) Brake Assembly #D-2-13 (modified per Piper Dwg. 31293)202. Tail wheel installations (a) Full swivel (Scott Aviation Model 3000B-2) + 5 lbs. (+ 200) *(b) Steerable - full swivel (Scott Aviation Model 3-24B) No Weight Change (c) Steerable - Lang Model D-501+ 2 lbs. (+ 200)

Electrical Equipment301. Battery (12 volt)+ 25 lbs. (+ 68)302. Positions lights+ 3 lbs. (+ 65)*303.Landing lights in wing leading edge (Grimes D-3650) per Dwgs. Nos. 1 & 2, Mountain States+ 4 lbs. (+ 5)304. Landing lights in wing leading edge per Piper Dwg. 12534+ 4 lbs. (+ 5)

Interior Equipment 401.One of the following CAA (FAA) Approved Airplane Flight Manuals revised to include any statement required under "Propellers and Propeller Accessories" and/or Item 103, if applicable.(a)Airplane Flight Manual dated March 24, 1947, or Piper Report No. 551 dated March 24, 1947 - includes Propeller Item 1 and O-235-C engine.(b)Piper Report No. 570 dated April 15, 1947, includes Propeller Item 3 and O-235-C engine.

The following placards must be displayed:(a) In front and in clear view of the pilot:"This airplane must be operated in compliance with the CAA Approved Operating Limitations(or Airplane Flight Manual)"In front and in clear view of pilot:"Normal Category - No acrobatic maneuvers including spins approved. "Utility Category - No acrobatic maneuvers.

The following placards must be displayed:approved except those listed below:"ManeuverEntry SpeedChandelles110 mphLazy Eights110 mphSteep Turns90 mph (X)