1. 1117166 MALE CLAMP2. 1703488 FEMALE CLAMP3. 1700369 CAP SCREW 3/8” X 1 3/4”4. 1700429 FLAT WASHER 3/8” 5. 1703331 Bulkhead weather seal

P/N 1117165 Rev B

2005 NISSAN FRONTIER DEUCE INSTALLATION SPECIAL INSTRUCTIONS

by TruXedo, Inc.P.O. Box 1078, 2209 Kellen Gross Dr., Yankton, SD 57078: 877- 878-9336 • : (605) 664-9304

CAUTION

These instructions replace steps 1, 3 and 4 in the Deuce owners manual.

Use standard clamps 1115191 at each end of the Utility Track.

Standard Clamp 1115191

Standard Clamp 1115191

Standard Clamp 1115191

Install Side Rails: With tailgate closed, align side rails fl ush with pickup bed rails and level with each other. Lightly compress D-seal against tailgate. Clamp side rails to bed rails, placing two clamps on fi xed portion of rails near ends of rails. Tighten securely. Note: the standard clamp 1115191 will be used at the rear and the non-standardclamp components will be used where the Utility track interferes with clamping. See step two in Deuce manual for further clamping information.

1

Install the Bulkhead weather seal across the front of the trucks bulkhead. Next install the underbody Rails. Fold back hinged portion of side rails, and stand inside pickup bed to install underbody rails.

2

Install Underbody Rails: Position underbody rails fl ush with Truxedo® Deuce side rails as shown. Clamp underbody rails to pickup bed.

3

To fi nish installation, continue with step 5 in the Deuce manual