8/8/2019 10 Up Range Rover Mesh Grille Installation Manual
Carid
2/4
2 Copyright 2010 by E&G Classics, Inc.
4. Install the supplied double faced tape to the emblemsurround
and install it onto the emblem mountingplate.
5. Use the remaining double faced tape the suppliedbrushed S. S.
L R emblem (not shown, or around theedge of the factory Land Rover
emblem and place a dabof silicone in the center of the factory
emblem), peel offthe tape backing, then align the emblem and press
itfirmly in place to set the tape. Once the silicone cures,the
emblem will be premanently installed.
4
6. Align the emblem in the approximate location as on thefactory
grille and install the black plastic washers, lockwashers and s.s
hex nuts and tighten to secure theemblem to the grille. Make sure
that the emblem is per-fectly level as you are tightening the
mounting hardware.
6
3. If reusing the factory emblem: Use a head gun andapply heat
to the back of the emblem recess to softenthe adhesive. Use caution
or you will melt the plasticfactory grille and may ruin the emblem.
Insert a razorblade between the emblem and grille recess and lift
theemblem out of the recess (careful, emblem and grille arehot).
Remove any adhesive from the back of theemblem once it cools.
3
2. Remove the factory grille by pulling the bottom of thegrille
straight out to release the lower mounting clips. Ifthe clips do
not pull out, use a long flat blade screwdriver and insert it
between the clip and the mountingpanel and twist to release.
1. Open the hood and remove the factory grille by press-ing down
and uncliping the four (4) clips across the topof the grille (one
side shown).
1
2
8/8/2019 10 Up Range Rover Mesh Grille Installation Manual
Carid
3/4
11. Press firmly down to properly seat the mounting pins. 12.
With the grille in place, push down on the outer edgesto make sure
that the grille is tight against the bumperover. Use a 5/32 drill
bit to grille through the outermounting tabs (as shown).
12
11
10. Install the upper mesh grille into place by pushing
themounting studs through the slots made in the previousstep.,
making sure you start at the center and workyour way towards the
sides.
6
Copyright 2010 by E&G Classics, Inc.
9. Use a .125 drill bit (1/8) to drill through the marksmade in
Step 7. Use the drill bit to connect the holesmaking mounting slots
in the bumper cover.
9
8. Tape up to the centers of the hole locations marked in
theprevious step. Tape up the sides of the headlight assem-blies to
prevent to protect them during the followingpaint and grille
installation procedures. Paint anythinginside the factory grille
opening, and on vehicles paintedcolors other than dark blue or
black, scuff and paint theexposed bumper cover that would be
visible through themesh grille.
8
7. Cut out and align the supplied upper grille hole
locationtemplate onto the bumper cover and use masking tape tohold
it in place. Use an awl or similar pointed tool tomark the hole
locations onto the bumper cover. Untapethe template, flip it over
and mark the holes on the oppo-site side.
7
