Embed Size (px)
Citation preview
1 V1.00 © 2009
ZelFlex QRQuick Released double-sided mechanical stretching frame
Step by step User guide
2
Assembly of protect frame
Frame without stencil
ZelFlex QR
V1.00 © 2009
3
Assembly of protect frame
Using the two hexagon-headed screws, attach the rear bar according to the stencil length.
Tighten them.
Rear bar must be parallel to the rear frame profile.
ZelFlex QR
V1.00 © 2009
4
Assembly of protect frame
Unwind the nuts from the stretching screws by about 10 mm.
ZelFlex QR
V1.00 © 2009
5
Assembly of protect frame
Remove the holding bars from the rear clamping and front stretching bars.
ZelFlex QR
V1.00 © 2009
6
Remove the holding bars in 3 steps:
Step 1 – Press the holding bar down
Step 2 - Move the holding bar to the right direction
Step 3 – Remove the holding bar
ZelFlex QR
V1.00 © 2009
7
Assembly of protect frame
Remove holdings bars and place them in front of and behind the frame.
ZelFlex QR
V1.00 © 2009
8
Place the stencil to the pins on the rear clamping bar.
ZelFlex QR
V1.00 © 2009
9
Assembly of protect frame
Close the rear clamping bar with the rear holding bar.
ZelFlex QR
V1.00 © 2009
10
Close the rear holding bar in 3 steps:
Step 1 – Place the holding bar to the rear clamping bar
Step 2 - Press down the holding bar and move it to the left.
Step 3 - Release the holding bar.
ZelFlex QR
V1.00 © 2009
11
Place the stencil to the pins on the front stretching bar.
ZelFlex QR
V1.00 © 2009
12
Assembly of protect frame
Close the front stretching bar with the front holding bar.
ZelFlex QR
V1.00 © 2009
13
Close the front stretching bar in 3 steps:
Step 1 – Place the holding bar to the front stretching bar
Step 2 - Press down the holding bar and move it to the left.
Step 3 - Release the holding bar.
ZelFlex QR
V1.00 © 2009
14
Assembly of protect frame
Tighten the stretching screw to get correct tension of the stencil.
ZelFlex QR
V1.00 © 2009
15
Assembly of protect frame
Gap between locker on stretching screw and bar should be approx. 3 mm for required working tension.
ZelFlex QR
V1.00 © 2009
16
Assembly of protect frame
Frame with stretched stencil from bottom side.
ZelFlex QR
V1.00 © 2009
17
Assembly of protect frame
Your ZelFlex QR frame is ready to use!
ZelFlex QR
V1.00 © 2009
18
ZelFlex QR
V1.00 © 2009
www.ZelFlex.com
19 © 2009
Thank you for your attention.LPKF Laser & Elektronika d.o.o. · Polica 33 · 4202 Naklo · Slovenia
