1 Lay-in fixture straight from carton to standard T-grid ......Grid Individual Lay-in fixture straight from carton to standard T-grid. SkyRidge Single Installation guide Metalux 1

Grid Individual

Lay-in fixture straight from carton to standard T-grid.

SkyRidge SingleInstallation guide Metalux

1 Install EQ clips (included) to ensure module can be re-installed during maintenance and inspection.2

Easy to wire through access on the back of the housing. Standard access plate may also be used with MWS.3 Quick disconnect and full length dimming leads included at

access opening to increase speed of installation.4

For visual demonstration purposes only. Use installation instructions for detailed step-by-step directions to ensure code compliance.

Eaton1000 Eaton BoulevardCleveland, OH 44122United StatesEaton.com

Eaton’s Lighting Solutions1121 Highway 74 SouthPeachtree City, GA 30269www.eaton.com/lighting

© 2018 EatonAll Rights ReservedPrinted in USAImprimé aux États-UnisImpreso en los EE. UU.Publication No. IB519096EN

Eaton is a registered trademark.All trademarks are property of their respective owners.

Eaton est une marque de commercedéposée. Toutes les autres marques de commerce sont la propriété de leur propriétaire respectif.

Eaton es una marca comercialregistrada. Todas las marcas comerciales son propiedad de sus respectivos propietarios.

Install rows based on layout produced from the Linear Price and Product Configurator. Tool-less opening and retention to access wiring raceway is standard. Contractor will have both hands free to complete the installation.


1 EQ clips are required for each housing section. LED modules are connected with simple plug-in connection. If preferred, they can be removed.

3

Tool-less installation with “pre-tension” torsion springs enable the ability to retain the module in the housing.4 Module will suspend easily to enable final inspection or to test

the light by turning it on before positioning the light guide into its fully installed position.5

Gently glide the light guide into position.6

Grid RowFor visual demonstration purposes only. Use installation instructions for detailed step-by-step directions to ensure code compliance.

Join housing internally using provided hardware - two screws.2







Length opening is important to ensure the housing can be rotated into position. 24' for 2 ft. fixture and 48' for 4 ft. fixture.


1

Housing is pushed through the opening and rests on the flanges. Ensure the bracket is on top of the ceiling. The bolt should be able to freely move vertically.

5 Fasten the bolt until it is tight against the ceiling. Do not over tighten with high torque. 6

Connect LED module on each section.8 Gently glide the light guide into

installed position. The flanges of the Drywall version LED module are wider than the housing. No exposed rough edges are present.

9

Unplug and remove LED module andset aside to complete the housing installation.

2 Drywall kit includes bracket and bolt. Install the bracket by attaching it through the housing in the appropriate sized hole.

3

Dry Wall/Hard CeilingFor visual demonstration purposes only. Use installation instructions for detailed step-by-step directions to ensure code compliance.

End plate for the Drywall version is extended to ensure rigid full engagement with ceiling.

4

Install LED module using tool-less torsion springs. Torsion springs include “pre-tensioning” clip for easier installation.

7







Documents

1 Lay-in fixture straight from carton to standard T-grid ......Grid Individual Lay-in fixture straight from carton to standard T-grid. SkyRidge Single Installation guide Metalux 1