Kwik-mold is dedicated to building tools that enable you to mold high-quality part quickly and profitably

1/1 Page No.:

19/292

Title:

Knout Out Holes Rev.: A

Created by: **** Approved by: **** Last Modified: 3.25.05

1.Used as the clearance holes for K.O. retainer.

2.the location and size of knockout holes:

The screw for K.O. retainer(1/2-13UNC or 5/8-11UNC.) should be machinined

per the above diagram unless otherwise specified.

Kwik-Mold Inc. Moldmaking Guide

This is the center position of sprue not the mold plates!

Inch Mold

Metric Mold