Embed Size (px)
Citation preview
Quick Configuration Guide
Website: www.dinstar.com Technical Support: [email protected]
Quick Configuration Guide
GSM/CDMA VoIP Gateway
Product Overview The DINSTAR DWG2000 GSM gateway enables providers to directly originate/terminate calls
from/to local GSM networks. It is a cost-effective SIP/GSM gateway for SOHO, SMEs and system
integrators, and also opens up new revenue generating opportunities for service providers.
The document suitable for following products:
□ DWG2001 GSM/CDMA VoIP Gateway
□ DWG2004 GSM/CDMA VoIP Gateway
□ DWG2008 GSM/CDMA VoIP Gateway
Part one (1) outgoing call settings 1. Access the web interface and check the SIM cards status:
The default IP address of LAN port is 192.168.11.1;
2. Add SIP server to be send traffic(IP configuration\ IP configuration):
Notes: can be added 32 SIP servers maximum
Quick Configuration Guide
Website: www.dinstar.com Technical Support: [email protected]
3. Add a group…(IP configuration\IP group)
4. Create a port Group... (Port group configuration\Port group)
5. Configure outgoing call routes… (Routing configuration\IP->Tel route)
Notes: Detination Prefix ‘any’ will match all digits of called number, it’s a wildcard.
6. Codec and other parameters configuration… (System configuration\service configuration)
6.1 Codecs…
Quick Configuration Guide
Website: www.dinstar.com Technical Support: [email protected]
6.2 Enable 1 stage dialing…
Set IP to PSTN one stage dialing to ‘Yes’;
6.3 Other parameter
Both ‘Allow call from PSTN to IP without registration’ and ‘Allow call from IP to PSTN without
registration’ set to ‘Yes’;
Part Two (2) incoming call settings
If you want to make incoming calls to specific extension or ring group automatically,
configure it as following steps: 1. Configure incoming route… (Routing configuration\IP->Tel route)
Incoming calls route to Elastix server
Quick Configuration Guide
Website: www.dinstar.com Technical Support: [email protected]
2. Incoming calls route to Elastix ’s extension number or ring group…
(System configuration\port configuration)
3. Enable auto call… (Operation\Tel->IP operation)
Part three (3) reject all the incoming calls—(optional)
If you needn’t incoming calls at all, create incoming reject rule as follow: 1. Add a Tel->IP routing…(Routing configuration\IP->Tel route)
Quick Configuration Guide
Website: www.dinstar.com Technical Support: [email protected]
2. Create a incoming reject rule…(Operation\Tel->IP operation)
