Upload
jessica-nelson
View
219
Download
0
Embed Size (px)
Citation preview
8/10/2019 009-0012-6001RE
1/4
Dual 50A 5X5 GMT TFA Fuse Alarm PanelWith Surge ProtectionModel 009-0112-6001RE Specification Sheet
Telect, Inc. USA +1.509.926.6000 Mexico +1.52.33.3836.3700
Poland +1.48.713.239.100 UK +1.44.1489.889500 www.telect.com
Copyright 2002 Telect, Inc., All Rights Reserved Telect Publication 127878-1 A2
NOTE
Inspect equipment after unpacking. Immediately report
any shipping damage, defects, or missing parts to Telectat 1-800-551-4567. Keep all documentation that comes
with your shipment
FEATURES& SPECIFICATIONS
Dual-Feed, 50A @ -48V Per Feed
5 GMT Outputs Per Feed
Diode-Clamped Output Surge Suppression
Power On & Fuse Alarm LEDs
Total Front Access
Inputs: Specifications:
Voltage & Range -48Vdc, -40V to -60V
Max. Input Load Rating 50A per side
Nominal Power Loss at FullLoad
20W per side @ 2400W full loadper side (50Ax48V)
Percentage of Full Load PowerDissipation at Nominal Voltage
less than 1%
Max. Input Interrupt Device 60A
Input Terminal Studs (WithKEPS Nuts) for Dual-HoleCompression Lugs
Two pairs ofdual#8-32 studs on5/8 in. centers. [Torque nut(using 11/32 in. or 9 mm socket)
to ~17 in.-lb (~1.8 Nm)]
Input Wire Size depends on input interruptdevice
GMT Outputs: Specifications:
Max. GMT Output Fuse (ea.) 15A.
Max. GMT Output Load (ea.) -continuous
12A
GMT Output Terminal Bare wire, ring, or forked lugunder #6-32 panhead screws.[~9 in.lb (~1 Nm) max, torque.)
GMT Output Wire Size #12 - #22 AWG (depends on out-put fuse rating)
Surge Protection > 68Vdc
Grounding: Specifications:
Earth GND terminal studs(With KEPS nut) for single-holdcompression lug (supplied)
Single #6-32 stud. Torque LEPSnut (using 5/16 in. or 8 mmsocket to ~8 in.lb (~1 Nm)
Ground Wire Size #10 - #18 AWG (depends oninput interrupt device)
Model 009-0112-6001RE is RoHS Exempt.
Alarms: Speci ficati ons:
Alarm Relay Contacts: Power Fail contacts are
normal when power is
applied to both feeds.
Fuse Alarm contacts are
normal if all installed fuses
are functioning
2A. @ 30 Vdc0.6A @ 60 Vdc
Max. Alarm Card Power Rating 1.9W (40mA @ -48Vdc)
Alarm Connection Wire binding plates under #2-56screws
Indicators: Specifications:INPUT POWER LEDs (Green) Lights when power is applied to
that feed
FUSE ALARM LED ((Red) Lights if any GMT fuse blows
Dimensions: Specifications:
Nominal, without brackets:*WidthHeightDepth* See Page 3 for details
17.25 in. (438 mm)1.75 in. (44 mm)4.00 in. (100 mm)
Weight: Specifications:
Weight, Without Packaging 5.75 lb (2.6 kg)
Weight, Shipping ~8 lb (~3.5 kg)
Environment: Specifications:
Operating Temperature Range -10C (14F) to 55C (131F)
8/10/2019 009-0012-6001RE
2/4
Telect, Inc. USA +1.509.926.6000 Mexico +1.52.33.3836.3700
Poland +1.48.713.239.100 UK +1.44.1489.889500 www.telect.com
Copyright 2002 Telect, Inc., All Rights Reserved Page 2
ADMONISHMENTS
WARNING!WARNING! WARNING! Failure to properly ground thi s equipment can create hazardous condit ions to installa-
tion personnel and to the equipment.
WARNUNG! Bei unsachgemer Erdung besteht Gefahr fr das Installationspersonal und das Gert!
AVISO! La conexin i ncorrecta a tierra puede ser peligrosa tanto para los instaladores como para el equipo.
AVERTISSEMENT ! Si vous ne rel iez pas cor rectement cet quipement la terre, son uti li sat ion prsente des
dangers pour la personne qui l'installe ainsi que pour l'quipement.
WARNING!WARNING! WARNING! Before connecting i nput power cables, make sure input power to panel is turned off.
WARNUNG! Vor Ansch luss der Eingangsstromkabel ist sicherzustellen, dass der Eingangsstrom ausge-
schaltet ist.
AVISO! Antes de conectar los cables de entrada de la alimentacin, compruebe que la alimentacin de
entrada al panel est cortada.
AVERTISSEMENT ! Avan t de connecter l es cbles d 'entre d'alimentat ion, assurez-vous que l'alimentat ion
lectrique est coupe au panneau.
SCHEMATICDRAWINGt
Note: The installer should
verify that a readily accessi-
ble 60-amp maximum over-
current protection device is
part of the building installa-
tion wiring feeding the fuse
panel.
ALARM PCB
1
INPUT A POWER
FUSE ALARM
C GND
-48V
RTN
RTN
-48V
INPUT A
INPUT B POWER
NO
C
NC
NC
C
NO
5
INPUT B
4
3
2
1
5
3
4
2
RTNGMT OUTPUT A
RTNGMT OUTPUT B
GMT OUTPUT B-48V
GMT OUTPUT A-48V
FUSE ALARM
POWER FAIL
5
1
3
4
2
3
5
4
1
2
8/10/2019 009-0012-6001RE
3/4
Telect, Inc. USA +1.509.926.6000 Mexico +1.52.33.3836.3700
Poland +1.48.713.239.100 UK +1.44.1489.889500 www.telect.com
Copyright 2002 Telect, Inc., All Rights Reserved Page 3
OUTLINEDRAWING
Telect assumes no liability from the application or use of these products. Neither does Telect convey any license under its patent
rights or the patent rights of others. This document and the products described herein are subject to change without notice.
NOTES:1. Dimensions are in in. (mm) or2. Panel not supplied with fuses.
in.mm
FRONT VIEW
TOP VIEW
B Input ShownWithout Cover
-48V Outputs Shown Without Cover
.625 (16.0)
8 - 32Studs
.19 (4.8)
6 - 32 Stud,KEPS Nut, & Lug
4.65 (118.1)3.99 (101.2)
17.25 [438.2]
1.73 [43.8]
8/10/2019 009-0012-6001RE
4/4
Telect, Inc. USA +1.509.926.6000 Mexico +1.52.33.3836.3700
Poland +1.48.713.239.100 UK +1.44.1489.889500 www.telect.com
Copyright 2002 Telect, Inc., All Rights Reserved Page 4