Quick Installation Guide

EnGenius Europe | Veldzigt 28, 3454 PW Utrecht (NL)0900-WIFIABC | www.wifiabc.com Disclaimer: Information may be subject to changes without prior notification. Follow us

https://www.linkedin.com/company/engeniuseurope

https://plus.google.com/+EngeniusEuropeBVDeMeernhttps://www.youtube.com/user/engeniuseuropebv

https://twitter.com/engeniuseu

Type ezhotspot.eu in your browser.

Select which option applies at your location.

Below ‘Quick Hotspots’ you can find even more options that may apply at your location.

Go to your network center, view the SSIDs (network names) and select ez@XXXXXX. You can find this address at the back panel of your product. Enter your password (this is also on the back panel).

Remove the rear bottom panel.

Connect one end of the Ethernet cable (not supplied) to the LAN (PoE) port on the EZ Hotspot Extender. The LAN (PoE) port can be founded on the right-hand side as seen from the back of the device.

Connect the other end of the Ethernet cable to the PoE injector’s PoE port. Connect the power cable of the PoE Injector and plug the power cord into an electrical outlet. The device is ready for configuring when the two LEDs (Power and Wireless) are lit and the green LED stops blinking. This may take about 30 seconds.

1

2

3

4

6

5