Coidak LED Lights
Create intelligent and green life for you!Coidak LED Lights
Coidak Panel Light http://www.amazon.com/dp/B00ZFI0V7O
Coidak Panel Light
Coidak Panel Light
Coidak Panel Light
Coidak Panel light FeaturesUltra thin: only 12mm thin, outer
diameter:6.7-inch, inner diameter: 6-inch,making panel light very
compact.Super bright: 12w,980lm,6500k,cool white led panel
light,2835 led chip,6030 aluminum, better heat dissipation.Energy
efficient: perfect equivalent of 98w incandescent, energy saving,
environment friendly without IR and UV radiation.Easy installation:
no warm up time required, no noise and no flickering, please cut
out a 6-6.2inch diameter hole to install.What You Get: Coidak Round
LED Panel Light Cool White 12W 6.7-Inch,LED driver,2 years warranty
and friendly customer service.
Coidak Panel Light Specifications Light color: White Diameter:
170mm/6.7" Inner diameter: 152mm/6" Lumens: 980lm Color Temp:6500K
LED chip: 2835 Power:12W Input AC voltage: 85V-265V Drive power
output:36-63VDC Shape: Round Life span: 50000h Weight: 0.56lb
CRI:85% Working Temperature:-25-65C
Coidak Panel Light reviews
I've installed too many recessed can lights in my day. I say too
many because I've always found them a major pain in the neck to
install. If you're working with new construction, it's not so bad:
just run the wires, install the lights between the joists, then cut
the drywall to fit over the light's circular opening. With old
construction and remodels, you have to cut a large hole in the
drywall, install the light (and often wiring), then create a
drywall patch that is the size of your opening minus the circular
light opening. I've always found this to be a major pain in the
behind.
This light was very easy to install, on the other hand. I just
cut the circular hole, connected the wires with wire nuts, and
popped the light in the hole. Now, if you're looking for BIG
ILLUMINATION via overhead spots, this light might not be the one
for you. Instead, it offers a nice subtle LED light. But as for
ease of installation on remodels, this light is a dream for any
contractor or DIYer.
I'm guessing we'll see more of these in the future, as they're
much easier to install than the old can lights that need to be
screwed to your joists or wedged in place via an expander. These
simply clip to the drywall around the hole and they're so light
that there is no drywall sag whatsoever.
Coidak Panel Light reviews
The inventor of can lights has a LOT to answer for. When I added
a bath ten years ago, the builder put a "can" over the walk-in
shower. He was proud of himself for steering me towards trendy
lighting. If I had known anything about them, I never would have
agreed to it. Since then I've heard horror stories about people
moving into their "dream homes" with hundreds of can lights and
using flashlights to navigate. I love everything about that
bathroom EXCEPT the can light.
Swapping it out for this round LED panel was as easy as anything
can be. It's true that I wouldn't have undertaken the job myself,
but my sister has done wiring on Habitat houses and she had no
trouble at all. Flip the breaker, pry the old can out of the hole,
disconnect the wiring. connect the wiring on the Coidak LED light,
and use the springs to hold it onto the drywall. It fit the
existing hole with no modifications and the flange covers the cut
edges of the drywall. Finito.
For my money, a 12watt LED light is a good light. It's so nice
to be able to see when I use that shower. Sure I know where all my
body parts are (I ought to, by this time) but I still like having a
light I can see by.
Coidak Panel Light reviews
The light fixture is a 6.7' round --very thin disk, that
contains very bright LED's. Its is very light weight, and very easy
to install. Its perfect for closets, or locations that need more
lighting, and either have a light fixture that is inadequate or you
want to change to cheaper LED lighting, or add an additional light
fixture.
The instructions are very limited--but looking at this--you will
notice two springs on the backside. This is nice becuase you do not
have to use any screws or electrical box to install this. You cut a
hole (per instructions) and the springs hold it in place.
If you were to replace a light fixture--you would change the
wires from the old to the new (this)--make sure the switch is off
(light is off) and you can use the hole that the old fixture used
(it might require minor modifications).
If you ADD this to the other light fixture--you would cut the
hole, and wire this into the other light fixture. If you do not
know how to do this, then you will have to get someone who does to
help you or do it for you. Its not hard, but it does require some
specific knowledge and experience to do it right.
It provides very bright, heat free, light, and is great---the
LED will last for hundreds of thousands of hours--and in my case, I
am replacing a light fixture that is difficult to change the
bulb---this will solve a couple problems, 1- expensive incandescent
light, 2- Hot --high heat output of light bulb, 3- very difficult
light bulb to change.
this will solve those and other problems. Once installed, it
will give you many years of trouble free very inexpensive
lighting.
Coidak Panel Light reviews
This is perfect! I was looking for a way to improve the lighting
in my bedroom over my computer desk and this was an affordable
option to go with. The downside is the installation process as you
will need to cut a hole in the area you want this, in our case the
ceiling. So be sure to measure carefully and accurately. Then you
need to wire it up properly. Thankfully my husband knows how to do
all that otherwise it wouldn't have gotten done.
The light is light weight, was easy to install for my husband,
but not something an average joe who knows nothing about
electrical, like myself, could do. While the light is not super
bright, it does provide a nice extra bit of lighting that I needed
over my desk in the evening times.
Thank you!
