If you can't read please download the document
Upload
juandigital
View
5.734
Download
1
Embed Size (px)
DESCRIPTION
This quick presentation teaches the proper way ti install safety wire on hardware. This can be used in aviation, racing or marine application. Safety wire holds better than other techniques and is not effected by heat or vibration. Plus it looks neat when done properly
Citation preview
2.
3. Cut enough safety wire to complete the task 4. Feed the wire through approximately half way through 5.
6. Start twisting the wire clockwise immediately upon exiting the bolt hole 7. Leave no gaps 8.
9.
10. Continue twisting clockwise 8-10 twists per inch 11. Do not over twist 12. 13.
14. Make sure safety wire has a tendency to pull the bolts tighter 15.
16. Go under the other wire 17.
18.
19. Continue twisting counter clockwise until about to inch. 20.
21. Fold end to make a pig tail 22. Congratulations!You just made a proper safety
23. Avoid nicking or damaging the wire in any way. This weakens it. 24. Avoid any gaps 25. VisitmyAandPlicense.comfor more information and findaviation mechanic schoolsnear you!