7 Dos And Donts In Rubber Calendering

DO’S and DONT’S�In�Calendering7

A Info-Series By Rubber Machinery World - http://rubbermachineryworld.com

Image Of A 4-Roll Calender Line at

Pelmar Engineering Limited, Israel.

http://rubbermachineryworld.com�

INFORMATION ON EQUIPMENT, TECHNOLOGY,

INNOVATION & SUPPLIERS M MRUBBER Rubber

MachineryWorld

» Use lab approved fabric and compound only.

» Clean the mill and calender guides including the

equipment surrounding area before starting unit.

» Load single strip of compound to both the cracker

mills. Then feed these compound to your holding mill.

» Always keep minimum compound in calender nips

and mills.

» Apply correct bleeder yarn.

» Put identification tags before storing your calendered

fabric in racks.

» Close cooling water lines to mills when mills are not

running

Choose Wisely.Operate Smartly

» Do not over load your two-roll mills and calender nips.

» Do not use held up compounds and dipped fabric.

» Do not stop unit with fabric in the line.

» Do not throw sheeted-out compound on the floor.

» Do not store calendered fabric on floor.

» Do not use damaged liner / baggy liner.

» Do not run mills with cooling water lines closed.