K10945 control assignment gajendra meena

CAREER POINT UNIVERSITY

MAJOR ASSIGNMENTON

Design and analysis of open loop transfer function

In modern era , control system play a vital role in human life. A control system is an interconnection of component forming a system configuration in which any quantity of interest or altered in accordance with a desired manner. The basic control system are :

Input Control system output

Definition Without feedback or non feed back control

system is known as open loop control system. The element of an open loop control system

can usually be divided into two parts:The actuating deviceThe controlled process

Open loop control systems are simple in construction.

Open loop control system in cheap. Generally the open loop systems are stable. The maintenance required for open loop

system is less. Calibration of open loop control system is

easily.

Open loop system are inaccurate. The accuracy is depend up on the calibration of input.

The open loop systems are not reliable, the operation of these is affected due to the presence of non linearties in its element.

Optimization of open loop system is not possible.

“The transfer function is define as the ratio of the Laplace transform of the output quantity to the Laplace transform of the input quantity, with all initial condition assumed to the zero.”

Then the transfer function is Transfer function=output/input

G(s)=Y(s)/R(s)

G(S)=Y(S)/R(S)

R(S) G(s) Y(s)

Its provide the gain of the system. Integral and differential equation are

converted to algebraic equation. The transfer function is dependent on the

parameters of the system and independent of the system.

If transfer function G(s) is known than any output for any given input , can be known.

Transfer function can be calculated only for linear and time invariant system.

Consider only when initial condition are zero. Its does not give any information about

physical structure of the system.

Zeros are defined as the root of the polynomial of the numerator of the transfer function.

Poles are the defined as the root of the polynomial of the denominator of the transfer function.

The value of s which are substitued in the denominator of the transfer function after substituting the value of y the transfer function becomes “infinite “, these values are called poles of the transfer function.

Like P1,P2,------Pn are those value which makes the transfer function infinite when substitute in previous equation.

The value of s which are substituted in the numerator of the transfer function, after substituting the value, the transfer function becomes “Zeros” these values are the called zeros of the transfer function.

Like Z1,Z2,--------Zn are those value which makes the transfer function zero.

When the value of poles and zeros are not repeated , such poles and zeros are called simple poles and zeros . If repeated such poles and zeros are called multiple poles and zeros .

The order of repeated pole and zeros is equal to the number of times they are repeated.

If all the poles of the system lie in left halfplane the system is said to be Stable.

If any of the poles lie in right half plane thesystem is said to be unstable.

If pole(s) lie on imaginary axis the system issaid to be marginally stable.

P1=[8 56 96]; Q1=[1 4 9 10]; Sys=tf(P1,Q1) Roots(P1); Roots(Q1); pzMAP(sys);

Num=[49]; Den=[ 1 4 9 ]; Sys=tf(num,den); load ltiexamples ltiview

Num=[49 89 96]; Den=[1 4 9]; Sys=tf[Num,Den]; Load ltiexamples ltiview