design verification of residential building

DESIGN VERIFICATION OF A RESIDENTIAL BUILDING

ByK.Azarudeen-13BCL0096S.Muthukumar-13BCL0304P.Mohankumar-13BCL0327

PROBLEM DEFINITION

• Design Verification of a residential building using a software - (Staad pro 2015) .

• Residential building of G+1 floor from a location(Pudukottai) is taken for verification

THE DESIGNED PLAN OF BUILDING

SNAPS OF THE BUILDING

VALUES ADOPTED

• SLAB: 0.15m (depth)• BEAM: 0.25m x 0.3m• COLUMN: 0.3m x 0.3m• LIVE LOAD: 3kN/m (maximum adopted)

DESCRIPTION

• The buildings live load and dead load is calculated from the type of material used and the dimensions

• Dimensions of slab, beams, column, footing of a residential building are verified for compliance to Indian Code

• M20 concrete and Fe415 steel have been used for this building• The plan and photos of the building are provided.

3D RENTERING OF THE RESIDENTIAL BUILDING

DEAD LOAD LIVE LOAD

LOAD COMBINATION OF DL & LL

EXCEL SHEET FOR RECTANGULAR BEAM CHECK

EXCEL SHEET FOR ONEWAY SLAB CHECK

EXCEL SHEET FOR TWOWAY SLAB CHECK

Learning basics of IS CODE Books

Designing a residential building

Make an Excel calculation to

design Beam,Coloumn,

Slab

Analysing the building in STAAD pro and

conclusion

Learning basics of

STAAD PRO

Steps involved

PARAMETERS 1st 2nd 3rd 4t

h1st 2nd 3rd 4th 1st

Learning basics of STAAD PRO

Learning basics of ISCODE BooksDesigning a residential building

Make an Excel calculation to

design Beam,Coloumn,

Slab

Verify the calculation values to STAAD PRO output values

2nd 3rd 4th 1st 2nd 3rd 4th

JULY AUGUST SEPTEMBER

OCTOBERACTIVITY CHART

ERRORS & MISTAKES

• Error caused in assigning the dimensions to the particulars

• Beams were not intersected properly which leads to error in calculation

• Not intersecting the slabs.• Assigning live load in wrong directions.• Worksheet assigning errors.• Assuming wrong standard values in calculations.

LEARNIGS

• Design a building using STAAD pro for • 1)Dead load and live load assigning• 2)Dimension assigning• 3) Basic kinds of possible errors• 4) Problems in automatic load design.• Learned to use excel sheet.• IS 875(part2) for residential building.• Basic design of Beams, Colums, Slabs in worksheet and

hand calculations.

REFERENCES

• IS: 875(part 1), IS: 875(part 2)• IS 456:2000, SP-16• https://youtu.be/Ae44Fp8JmKE• staad pro and excel tutorials from youtube

CONCLUSIONS

• The resistance to the live load and dead load is verified for beams,columns,and slabs of the building.

• The results were compared to the actual plan and the safety criteria is checked.