View
58
Download
0
Category
Preview:
Citation preview
JAPAN AIRLINESBOEING 767-300ERAssembly method
You need prepare adhesive and nippers for assembly. You need prepare water and dry towel for stick seal. If you want to paint, you need paints.
Step 1 Engine Assembly
D9
D10
D12
D13
D9
D15
D14D11
Left EngineRight Engine
You cut D9~D15 parts. D9, D10, D12 and D13 is right engine parts. D9, D11, D14 and D15 is left engine parts. You assemble those parts with the use of adhesive.
Step 2 Fuselage Assembly
C5
B1
BALLAST PARTS
A1
A weight is put on the front to put gravity at the front. A weight is that C5 is insert screw BALLAST PARTS.This step is big parts of all step. But, The place where glue is put is small.
Step 3 Main Gear Installation
This Step is made very small parts. D3(D4) will be put on other parts. C7(C6) is D3(D4)’s outside and D5(D6) is D3(D4)’s inside. When glue isn't put tightly, it comes off. So, It is need to put glue tightly.
D5D7
C7
D7
D3 D4
C6
D6
Step 4 Nose Gear Installation
First, you will cut C8 and D8. Because a part is small, please be careful.Next, attach 2 of D8(tire) to C8.
D8
C8
Step 5 How to make shuttlecockFirst, you cuts parts C1, C2, D1 and D2.
And then C1 and D2 join, C2 and D1 join. Second, you cuts parts C3 and C4.
D2
C2C1
C3 C4D1
Fourth, paste a pasteboard to plane with wet fingersFinally, take off a pasteboard leaves a sticker on the plane
Step 6 How to put stickersFirst, cut each a sticker with pasteboard which you want to use.Second, float a pasteboard on the water for about 20 secondThird, place a pasteboard on a tissue paper to dry
Recommended