WIFI SCANNING - Remote Engineer

1

WIFI SCANNING REMOTE ENGINEER

REMOTE ENGINEER BV IT VEGELINSKAMPKE 11 8491 PD AKKRUM +31 566 796 515 INFO@REMOTEENGINEER.EU

2

Connect the ServiceGate to a wireless access point.

1. Go to ‘Network’ and click on ‘Wireless’.

2. Click ‘SCAN’.

3

3. Look for the network you want to connect to and click ‘JOIN NETWORK ‘.

4. (Optional) If you want to replace the current wifi configuration, check ‘replace wireless configuration’. Click ‘SUBMIT’.

4

5. Do you want to turn on wifi when booting up? Then check ‘Enable wifi at boot’. If you chose a “hidden network” then you need to fill in the “ESSID”. After that, click ‘SAVE & APPLY’.

6. You should now see the following screen. If this it not the case, you’ll need to reboot the ServiceGate.

7. The ServiceGate is now connected with the selected wifi network.

5

Contact informationRemote Engineer B.V.It Vegelinskampke 11,8491 PD Akkrum (The Netherlands)www.remoteengineer.eu,Tel: +31 566 796 515,sales@remoteengineer.eu

Copyright © 2020 Remote Engineer B.V. All rights reserved.

6REMOTE ENGINEER BV IT VEGELINSKAMPKE 11 8491 PD AKKRUM +31 566 796 515 INFO@REMOTEENGINEER.EU