View
115
Download
12
Category
Preview:
DESCRIPTION
UN 2000-06 Part 3 E (1997-02)
Citation preview
Continued on pages 2 to 3
KRUPP UHDE STANDARD February 1997
Vessels and equipment
CLIPSfor guide and support brackets for piping
Type C
UN2000-06
Part 3
Behlter und Apparate; Anschlubleche (Clips); fr Fhrungs- und Tragkonsolenfr Rohrleitungen, Typ C
Supersedes 91-06
Dimensions in mm
Type 1C Type 2C
Type 3C Type 4C
Date Prepared Date Checked Date Approved
1997 Krupp Uhde GmbH Technical discipline: EN-EP
Page 2 UN 2000-06 Part 3
Type 5C Type 6C
Type 7C Type 8C
UN 2000-06 Part 3 Page 3
Type 9C
Remarks1. All ribs are 10 mm thick and be joined by a continuous filled weld with a = 0.7 x smallest wall thickness.
The fixing plates of type 1C and 2C are 10 mm thick, all other types are 15 mm thick.2. When clips are welded within the area of vessel seams the clips shall be recessed. See Krupp Uhde stan-
dard UN V416-01 Part 1.3. For location and dimensions B, C and k see vessel drawing and Krupp Uhde standards UN 3789-04 .4. Materials for clips:
For vessels of carbon steel and of low-alloy steel subjected to operating temperatures between -10C and250C: vessel material or killed carbon steel. In case of temperatures below -10C or above 250C: vesselmaterial or a suitable cold ductile respectively a heat resisting steel.For vessels made of high-alloyed steel: vessel material.For vessel material resistant to pressure hydrogen, refer to Krupp Uhde standard UN 2000-01 Part 1.
5. In case a reinforcing plate is required between vessel wall and clip, a 'V' is added to the clip type, e.g. 7CV.
Reference StandardsUN 2000-01 Part 1 Pressure vessels; general specificationUN 3789-04 Pipe supports; Guide and support brackets for piping for vessels and equipmentUN V416-01 Part 1 Welded joints for vessels and equipment; requirements
Recommended