Traction Performance of Wheel and Track for Soft...

Traction Performance of Wheel and Trackfor Soft-Soil Traversal

Kazuya Yoshida, Keiji Nagatani,Junya Yusa

Tohoku University, Japan

ICRA‘10 Planetary Rovers WorkshopMay 3rd, 2010

Traction Performance of Wheel and Trackfor Soft-Soil Traversal

IntroductionResearch Setup

The Sand BoxThe Test Beds

Traction Performance EvaluationExperimental Results for Wheel v.s. TrackHow can we improve the wheel traction?

Summary

Rover Test Beds in Tohoku Univ. since 1997

“Kaguya”a Japanese Lunar Orbiter

Launched on September 14, 2007.Orbiting 100km lunar polar orbit for global mapping and

remote sensing of the Moon.

Apollo mission © NASA

Lunar Rovers

Most of lunar surface is covered with soft soils (regolith).

Wheel slippages/skids are unavoidable.

Critical situations (immobility due to wheel spin, side slide, or tip over) should be avoided.

Maximize the traction performance and power efficiency

Modeling and control based on substantial analysis of traction mechanics is important.

Wheeled rovers can be stuckin loose soil

NASA’s Mars Exploration Roversalso experienced difficulty.

© NASA

© JAXA

Do tracks work better than wheels?

Advantages of Tracked Vehicles:• Higher slope-climbing capability• Higher bump-crossing capability*

(*This is only true when the length of the track is larger thana “wave length” of the bumps.)

Disadvantages of Tracked Vehicles:• Higher mass and higher energy consumption• Higher complexity of mechanism• Higher risk of track jamming or other mechanical

failures

Traction Performance of Wheel and Trackfor Soft-Soil Traversal

IntroductionResearch Setup

The Sand BoxThe Test Beds

Traction Performance EvaluationExperimental Results for Wheel v.s. TrackHow can we improve the wheel traction?

Summary

18

Toyoura-sand: a standard soil in Terramechanics research community

The Sand Box

19

Mono-Crawler Inline Four-Wheels

Length = 400 mm, Width = 40 mm, Weight = 6 - 18 kgfor Crawler: 375 - 1125 kg/m2 (0.53 – 1.60 psi)for Wheels: 1.5 - 4.5 kg/wheel

The Test Beds

20

Mono-Crawler Inline Four-Wheels

Slope Angle: 0 – 16 degs (physically)

0 – 30 degs (equivalently)

The Test Beds

Traction Performance of Wheel and Trackfor Soft-Soil Traversal

IntroductionResearch Setup

The Sand BoxThe Test Beds

Traction Performance EvaluationExperimental Results for Wheel v.s. TrackHow can we improve the wheel traction?

Summary

Slip Ratio

vd ： circumference velocity of crawler belt or wheelv ： body velocity of the test bed

22

Slip Ratio － Drawbar Pull Slip Ratio － Slope Angle

1d

d d

v v vsv v−

= = −

Performance Evaluation

Drawbar Pull (DP)

DP = Traction Force - Resistance

23

Q: Is the slope climbing condition equivalently tested by the increased horizontal load?

1tan x

z

FF

θ −=

24

Q: Is the slope climbing condition equivalently tested by the increased horizontal load?

A: Yes, that seems true as long as no landslide (avalanche) occurs.

Experimental Result 0 (track)

25

26

0

1

2

3

4

5

6

7

8

9

10

0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1

draw

bar pu

ll [kg]

slip ratio [‐]

8.8kg11.8kg14.8kg17.8kg

Experimental Result 1a (track)

The Drawbar Pull increases along with the vertical load Fz.

Experimental Result 2a (track)

27

0

5

10

15

20

25

30

0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1

slop

e an

gle [deg]

slip ratio [‐]

8.8kg11.8kg14.8kg17.8kg

But the ratio of DP/Fz (= slope angle) is not affected by Fz.This fact suggests that the traction force Fx is in proportion to the vertical load Fz (like friction), and the resistance R is relatively small. DP/Fz = Fx/Fz － R

28

0

5

10

15

20

25

30

0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1

slop

e an

gle[de

g]

slip ratio[‐]

2cm/s

4cm/s

Experimental Result 3a (track)

Velocity dependency is not observed between 2 and 4 cm/s.

29

Experimental Result 1b (wheel)

0

1

2

3

4

5

6

7

8

9

10

0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1

draw

bar pu

ll [kg]

slip ratio [‐]

8.8kg11.8kg14.8kg17.8kg

0

1

2

3

4

5

6

7

8

9

10

0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1

draw

bar pu

ll [kg]

slip ratio [‐]

6kg9kg12kg

track wheel

Drawbar Pull v.s. Slip Ratio

30

Experimental Result 2b (wheel)

track wheel

Slope Angle v.s. Slip Ratio

0

5

10

15

20

25

30

0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1

slop

e an

gle [deg]

slip ratio [‐]

8.8kg11.8kg14.8kg17.8kg

0

5

10

15

20

25

30

0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1

6kg9kg12kg

slip ratio [‐]

slop

ean

gle[deg]

Experimental Result 1b (wheel)

31

This fact suggests that the wheel traction is NOT like friction, because of relatively large the resistance R due to wheel sinkage.

In wheel, DP is not much affected by Fz.

0

0.5

1

1.5

2

2.5

0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1

draw

bar pu

ll [kg]

slip ratio [‐]

6kg

9kg

12kg

DP/Fz = Fx/Fz － R

Traction Model for a Rigid Tire on Soft Soil

( ) ( ){ }

( ) ( ){ } θθθσθθτ

θθθτθθσ

θ

θ

θ

θ

drbDP

drbW

f

r

f

r

∫

∫−=

+=

sincos

sincos

( ) ( )( )( ) ( )( )[ ]θθθθ

ϕσθτ

sinsin1

1tan)(

−−−−−=

−+=

ff

sa

skrsa

ec

(Bekker 1956, Wong 1978)

∫= f

r

dbrTθ

θθθτ )(2

33

Weight = 9kg , slope angle = 10°

Slip Ratio = 0.054 Slip Ratio = 0.774

Comparison of Track and Wheel

35

116m

m

202m

m327m

mQ: How can we improve the traction

performance of the wheels?

Wheels with Different Dimensions

36

D=100mm D=200 D=300diameter [mm] 116 202 327lug height [mm] 5 9 15number of lugs 24 24 24width [mm] 50, 100, 150 50, 100, 150 50, 100, 150

D=100 D=200 D=300

With Larger Diameter

37（width = 100mm）

38

各車輪径におけるスリップ率 と斜度の関係（車輪幅 = 100mm）

θ = 12°φ300mm s = 0.056

θ = 12°φ100mm s = 0.741

θ = 12°φ200mm s = 0.229

With Larger Diameter

39

（D = 200mm）

With Larger Width

40

各車輪幅におけるスリップ率 と斜度の関係（車輪径 = 200mm）

θ = 14°w50mm s = 0.471

θ = 14°w100mm s = 0.320θ = 14°w150mm s = 0.247

With Larger Width

41

0

5

10

15

20

25

30

0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1

slop

e an

gle [deg]

slip ratio [‐]

8.8kg11.8kg14.8kg17.8kg

0

5

10

15

20

25

30

0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1

slop

e an

gle [‐]

slip ratio [‐]

w50mm

w100mm

w150mm

track wheel

Comparison of Track and Wheel

42

Q: How can we improve the traction performance of the wheels?

Yeswith increased contact areawith decreased wheel sinkage

Example:Michelin Tweel®

Deformable Tire

Traction Performance of Wheel and Trackfor Soft-Soil Traversal

IntroductionResearch Setup

The Sand BoxThe Test Beds

Traction Performance EvaluationExperimental Results for Wheel v.s. TrackHow can we improve the wheel traction?

Summary

Summary

The traction performance was experimentally studied to compare track (mono-crawler) and wheel (inline wheels).The slope climbing condition was equivalently tested by the increased horizontal load.The track showed higher performance than wheels.The track performance can be modeled like a surface friction, with very small sinkage related resistance. The wheel performance is largely disturbed by the wheel sinkage.But the performance of the wheels can be improved with grater diameter and width, which resulting in smaller sinkage.

The Space Robotics Lab.Dept. of Aerospace Engineering

Tohoku University, JAPANDirected by Prof. Kazuya Yoshida

yoshida@astro.mech.tohoku.ac.jphttp://www.astro.mech.tohoku.ac.jp/home-e.html

Free-Flying Space Robot

Planetary Exploration Rovers Asteroid Sampling

Robotic Systems on ISS

The SPACE ROBOTICS

Lab.