View
214
Download
1
Category
Preview:
Citation preview
Stanley
HP-1Compact Power Unit
Safety Rules
Never operate unit in closed spaceMake sure fittings are tightNever use flammable solvents near power unitWear safety equipment
Do not operate unit if gasoline odor is presentKeep unit 1 meter away from buildingsAllow unit to cool before putting away
Do not change governor components
Hydraulic Fluid Requirements
Tank capacity is 2.7 galViscosity 50deg F 450 SSU 100deg F 130-200 SSU 140 deg F85 SSU
Hydraulic Filter
Filler Cap
Hydraulic Site Gauge
Hydraulic Reservoir
Engine Type
Gasoline powered18 horse power, twin cylinderBriggs / Stratton Vanguard EngineUse unleaded gasolineUse oil classified “for service SF,SE,SD,SC” 10W/30
Battery
Oil DipstickOil Fill
Fuel Tank
Fill Cap
Choke
Tool Hose
Use two 1/2in diameter hoses rated for working pressure of 2500psi15-25 feet long
Preparation for Use
Check crankcase oilCheck fuel levelCheck hydraulic fluidCheck batteryConnect hoses
Hydraulic Site Gauge
Oil Dipstick
Site Gauge
Oil Dipstick
Operating Instructions
Place hydraulic control lever in the “tool off” positionSelect the “auto” throttle modePlace Engine On/Off switch in the “On” positionPush hydraulic control lever to “Start” position
Engage choke if neededWhen engine starts, release the control leverTo the “tool off” positionWhen engine is warm, select the mode of operation (Auto or Hold 8 or 5 gpm)
Tool Control Lever
Start Tool Off
Throttle Plate
Water Pump Location
Cold Weather Operation
If used in cold weather you must preheat the hydraulic oil at low engine speedOil temp should be at or above 50 deg F before useRun engine at low speed with control lever in “tool off” position
Recommended