View
224
Download
6
Category
Preview:
Citation preview
Vehicle CCTV Monitor
Quick Installation Guide
Digital LCD Color MonitorPlease read this manual thoroughly before operating the unit,
and keep it for future reference.
V1.0
Serial No: Stock code:
Disclaimer
Camera monitor systems are an invaluable driver aid but do not exempt
the driver from taking every normal precaution when conducting a
manoeuvre. No liability arising out of the use or failure of the product
can in any way be attached to the distributor.
11
1. Products
2. Monitor installation
4. Controls
5. Operation
6. Specifications
Contents
3. Connections
………………………………………
………………………………………………
………………………………………………………
……………………………………………
……………………………………………
………………………………………………………… 1
2
3
4
10
………
………………
……
5
The product is aimed at assisting in safe driving and provides the driver with a broader field
of vision. As the driver, you are solely responsible for the appropriate operation of your
vehicle and the safety of your passengers and pedestrians, and you should abide all state
and local traffic laws and regulations. Do not over use any features of this system that it
might distract you from safe driving. The top priorityof your driving should always be the
safe operation of your vehicle. A&I Products Inc will not accept any responsibility/recourse
whatsoever for accidents and/or injuries resulting from failure to observe these precautions
or safety instructions.
! Special Notice
Specification
Waterproof Camera
1.
2. GND
3.
4.
5 .
1
2 3
4
5
12V DC
Shell.
Audio Output
Video Output
1
2 3
4
Image Device 1/3” CMOS PC1089K
TV System PAL NTSC
Effective Pixels 728*488 pixels
Sensing Area 4.6228mm*3.6112mm
Scanning System 2:1 Interlace
Sync. System Internal
Resolution 500TV Lines
Horizontal Sync Frequency 15.625 kHz 15.734 kHz
Vertical Sync Frequency 50 Hz 60 Hz
Video Output 1.0Vp-p, 75Ohm
Gamma Consumption 0.45
AGC Auto
S/N Ratio Better than 48dB
White Balance Auto
Electronic Shutter 1/60(NTSC)/1/50(PAL)~1/100,000 Seconds
BLC Auto
Storage Temperature –40℃ ~ 80℃, RH95%MAX
Operating Temperature –40℃~70℃, RH95%MAX
Power Supply DC12V
Waterproof rating IP69K
Viewing Angle 120°
Audio Yes
Minimum Illumination 0 Lux
Night vision distance 20~25m
Image mode Mirror/Normal image switch
Heater No
IR CUT Yes
Sun Shield
1 .Products
Monitor IR Remote Control
1
AV and Power Supply Conversision Cable
Center Mount Bracket
MODE SEL.
IMG REST DVD
DN
MENU
UP
VOL VOL
MUTE POWER
P/N
U-Support Bracket &&
Angle Adjustment Screws
6. Specifications
10
= VOL-
= VOL+
fast
(lift o
ff)
Any display mode
fast
(lif
t o
ff)
BACK RIGHT
BACK RIGHT
5.4.7
5.4.8
Any display mode
9
9
10~32
234(w)x158(h)x39.75(d)mm
2
Touch
LEFTRIGHT
FRONT BACK
Press lease
RIGHT
FRONT LEFT
BACK
LEFT RIGHT
Press for at
least 3 secondsFRONT
Keep touch
LEFT
BACK
RIGHT
= Display mode selection
Any display mode
Last position
Prevbus position
9
= Display mode selection
Any display mode
fast
Last position
Prevbus position
BACK RIGHT
BACK RIGHT
BACK RIGHT
2 .Monitor installation
2
Center Mount Bracket
FRONT
Keep touch
5.4.3 Any multi mode
5.4.4 Any double or triple display
Touch
5.4.5
5.4.6
(lift off)
(lift off)fast
LEFT
Touch
BACK
RIGHT
3A Fuse
RCA Yellow
RCA White
RCA Green
4P White
5P Brown
4P Blue
4P Green
3.5MM AUX Connector
A
B
C
D12345678
9
10
11
1 2 3 4
5 6 7 8
9 10 11
Camera 1A B C DCamera 2 Camera 3 Camera 4
Red: Power White: Trigger 1 Black: Ground Blue: Trigger 2
Brown: Trigger 4 Green: Trigger 3 Yellow: Split LIVE_VOUT
REC_VOUT AV_AINAOUT
again
(6)
Channel or item on menu selection up/down
(7) Item on menu selection decrease/adding
( 5 )
Touch
Touch origin display mode
8
MAIN MENU
OSD SETUPSYSTEM SETUPTRIGGER SETUPTRIGGER PRIORITYRESET ALL
CAMERA SETUP
3 .Connections
3
IR Signal Sensor1
Automatic low light sensor7
2 Power key
4
3
5
6
1 2 3 4 5 6 7
The mode set in the main menu
The Original
display mode
1 2 3 4
4
(3)
Touch Screen
Any multi mode
Any display mode
(1) Touch
(2) Touch
Original display mode
(4) Press to adding/decrease the brightness level.
LEFT
Touch
/ / /1 2 3 4
/
7
LEFT RIGHT
BACK
vol IIIIIIIIIIIIIII 1S
The display mode which
you set in main menu
TOUCH MENU AREA
FRONT
FRONT
LEFT RIGHT
BACK
TOUCH
LEFT
5.4
5.4.1
TOUCH MENU AREA
5.4.2
4 .Controls
S
5 .Operation
5.2 Trigger Setting
MAIN MENU
OSD SETUPSYSTEM SETUPTRIGGER SETUPTRIGGER PRIORITYRESET ALL
CAMERA SETUP
MAIN MENU
OSD SETUPSYSTEM TRIGGER SETUPTRIGGER PRIORITYRESET ALL
CAMERA SETUP
SETUP
MAIN MENU
OSD SETUPSYSTEM SETUPTRIGGER SETUPTRIGGER PRIORITYRESET ALL
CAMERA SETUP
TRIGGER SETUPTURN IMAGE SINGLEREAR IMAGE BACKDELAY 03SECDOUBLE SCREEN:LEFTWARD LEFTRIGHTWARD RIGHTAUDIO LEFT LEFT
MAIN MENU
OSD SETUPSYSTEM SETUPTRIGGER SETUPTRIGGER PRIORITYRESET ALL
CAMERA SETUP
SYSTEM SETUP
SCAN OFFSCAN DELAY 01 SECJUMP KEY LEFTP-ON MODE Y-SPLITBEEP ONSYSTEM NESCBACK LIGHT 05
REC-V OUT QUAD
LEFT H-SPLIT
RIGHT TREFOIL
FRONT Y-SPLIT
BACK
QUAD
DUAL
TRIPLE
PIP2
PIP2
PIP3
MAIN MENU
OSD SETUPSYSTEM SETUPTRIGGER SETUPTRIGGER PRIORITY
CAMERA SETUP
5 6
MAIN MENU
OSD SETUPSYSTEM SETUPTRIGGER SETUPTRIGGER PRIORITYRESET ALL
CAMERA SETUP
OSD SETUP
REAR GAUGE ONINPUT SCAN OFFBOUNDARY WHITE
_ +/
_ +/
_ +/
S
S
5.1 OSD Setting
5.3 Jump Key Setting
S
5 .Operation
5.2 Trigger Setting
MAIN MENU
OSD SETUPSYSTEM SETUPTRIGGER SETUPTRIGGER PRIORITYRESET ALL
CAMERA SETUP
MAIN MENU
OSD SETUPSYSTEM TRIGGER SETUPTRIGGER PRIORITYRESET ALL
CAMERA SETUP
SETUP
MAIN MENU
OSD SETUPSYSTEM SETUPTRIGGER SETUPTRIGGER PRIORITYRESET ALL
CAMERA SETUP
TRIGGER SETUPTURN IMAGE SINGLEREAR IMAGE BACKDELAY 03SECDOUBLE SCREEN:LEFTWARD LEFTRIGHTWARD RIGHTAUDIO LEFT LEFT
MAIN MENU
OSD SETUPSYSTEM SETUPTRIGGER SETUPTRIGGER PRIORITYRESET ALL
CAMERA SETUP
SYSTEM SETUP
SCAN OFFSCAN DELAY 01 SECJUMP KEY LEFTP-ON MODE Y-SPLITBEEP ONSYSTEM NESCBACK LIGHT 05
REC-V OUT QUAD
LEFT H-SPLIT
RIGHT TREFOIL
FRONT Y-SPLIT
BACK
QUAD
DUAL
TRIPLE
PIP2
PIP2
PIP3
MAIN MENU
OSD SETUPSYSTEM SETUPTRIGGER SETUPTRIGGER PRIORITY
CAMERA SETUP
5 6
MAIN MENU
OSD SETUPSYSTEM SETUPTRIGGER SETUPTRIGGER PRIORITYRESET ALL
CAMERA SETUP
OSD SETUP
REAR GAUGE ONINPUT SCAN OFFBOUNDARY WHITE
_ +/
_ +/
_ +/
S
S
5.1 OSD Setting
5.3 Jump Key Setting
IR Signal Sensor1
Automatic low light sensor7
2 Power key
4
3
5
6
1 2 3 4 5 6 7
The mode set in the main menu
The Original
display mode
1 2 3 4
4
(3)
Touch Screen
Any multi mode
Any display mode
(1) Touch
(2) Touch
Original display mode
(4) Press to adding/decrease the brightness level.
LEFT
Touch
/ / /1 2 3 4
/
7
LEFT RIGHT
BACK
vol IIIIIIIIIIIIIII 1S
The display mode which
you set in main menu
TOUCH MENU AREA
FRONT
FRONT
LEFT RIGHT
BACK
TOUCH
LEFT
5.4
5.4.1
TOUCH MENU AREA
5.4.2
4 .Controls
3A Fuse
RCA Yellow
RCA White
RCA Green
4P White
5P Brown
4P Blue
4P Green
3.5MM AUX Connector
A
B
C
D12345678
9
10
11
1 2 3 4
5 6 7 8
9 10 11
Camera 1A B C DCamera 2 Camera 3 Camera 4
Red: Power White: Trigger 1 Black: Ground Blue: Trigger 2
Brown: Trigger 4 Green: Trigger 3 Yellow: Split LIVE_VOUT
REC_VOUT AV_AINAOUT
again
(6)
Channel or item on menu selection up/down
(7) Item on menu selection decrease/adding
( 5 )
Touch
Touch origin display mode
8
MAIN MENU
OSD SETUPSYSTEM SETUPTRIGGER SETUPTRIGGER PRIORITYRESET ALL
CAMERA SETUP
3 .Connections
3
Touch
LEFTRIGHT
FRONT BACK
Press lease
RIGHT
FRONT LEFT
BACK
LEFT RIGHT
Press for at
least 3 secondsFRONT
Keep touch
LEFT
BACK
RIGHT
= Display mode selection
Any display mode
Last position
Prevbus position
9
= Display mode selection
Any display mode
fast
Last position
Prevbus position
BACK RIGHT
BACK RIGHT
BACK RIGHT
2 .Monitor installation
2
Center Mount Bracket
FRONT
Keep touch
5.4.3 Any multi mode
5.4.4 Any double or triple display
Touch
5.4.5
5.4.6
(lift off)
(lift off)fast
LEFT
Touch
BACK
RIGHT
Sun Shield
1 .Products
Monitor IR Remote Control
1
AV and Power Supply Conversision Cable
Center Mount Bracket
MODE SEL.
IMG REST DVD
DN
MENU
UP
VOL VOL
MUTE POWER
P/N
U-Support Bracket &&
Angle Adjustment Screws
6. Specifications
10
= VOL-
= VOL+
fast
(lift o
ff)
Any display mode
fast
(lif
t o
ff)
BACK RIGHT
BACK RIGHT
5.4.7
5.4.8
Any display mode
9
9
10~32
234(w)x158(h)x39.75(d)mm
2
Serial No: Stock code:
Disclaimer
Camera monitor systems are an invaluable driver aid but do not exempt
the driver from taking every normal precaution when conducting a
manoeuvre. No liability arising out of the use or failure of the product
can in any way be attached to the distributor.
11
1. Products
2. Monitor installation
4. Controls
5. Operation
6. Specifications
Contents
3. Connections
………………………………………
………………………………………………
………………………………………………………
……………………………………………
……………………………………………
………………………………………………………… 1
2
3
4
10
………
………………
……
5
The product is aimed at assisting in safe driving and provides the driver with a broader field
of vision. As the driver, you are solely responsible for the appropriate operation of your
vehicle and the safety of your passengers and pedestrians, and you should abide all state
and local traffic laws and regulations. Do not over use any features of this system that it
might distract you from safe driving. The top priorityof your driving should always be the
safe operation of your vehicle. A&I Products Inc will not accept any responsibility/recourse
whatsoever for accidents and/or injuries resulting from failure to observe these precautions
or safety instructions.
! Special Notice
Specification
Waterproof Camera
1.
2. GND
3.
4.
5 .
1
2 3
4
5
12V DC
Shell.
Audio Output
Video Output
1
2 3
4
Image Device 1/3” CMOS PC1089K
TV System PAL NTSC
Effective Pixels 728*488 pixels
Sensing Area 4.6228mm*3.6112mm
Scanning System 2:1 Interlace
Sync. System Internal
Resolution 500TV Lines
Horizontal Sync Frequency 15.625 kHz 15.734 kHz
Vertical Sync Frequency 50 Hz 60 Hz
Video Output 1.0Vp-p, 75Ohm
Gamma Consumption 0.45
AGC Auto
S/N Ratio Better than 48dB
White Balance Auto
Electronic Shutter 1/60(NTSC)/1/50(PAL)~1/100,000 Seconds
BLC Auto
Storage Temperature –40℃ ~ 80℃, RH95%MAX
Operating Temperature –40℃~70℃, RH95%MAX
Power Supply DC12V
Waterproof rating IP69K
Viewing Angle 120°
Audio Yes
Minimum Illumination 0 Lux
Night vision distance 20~25m
Image mode Mirror/Normal image switch
Heater No
IR CUT Yes
Recommended