Proteus ISIS

A Very Brief Introduction TO ISIS Proteus

CPE 110 Computer Exploration

August 21, 2009

1 1 Editing Window

2 2 Object Selector

3

A Guide To ISIS : Proteus

2 2 Object Selector

3 Overview Window

Tools and Buttons

Component List

Pick a DevicePick a Device

Ground and terminals

Signal generators(sources)

Instruments(Scope, meters)

Tools and Buttons

Device rotation

Device horizontal flip

Device vertical flipDevice vertical flip

Run a simulation

Stop the simulation

Pick a Device: LAMP

Click on P to pick a device.

Pick a Device: LAMP

Type Bulb to search for a light bulb

Double click on LAMP to select a lamp

Notice the LAMP in the Object Selector

Pick a Device: CELL

Type Battery to search for a battery

Double click on CELL to select a dry cell battery

Pick a Device: Push Button Switch

Type Button to search for a push button switch

Double click on BUTTON to select a push button switch

Pick a Device: Resistor

Type Resistor to search for a resistor

Scroll down the sidebar and look for RESDouble click on RES to select a resistor

Place a Device: CELL

Rotate a Device: Push Button

Select Button

Rotate a Device: Push Button

Click on Set Rotation button to set the rotation as shown

Draw a Circuit

The First Circuit

Run a Simulation

Pick a Device: Capacitor

Type Cap to search for a capacitor

Scroll down the sidebar and look for CAPDouble click on CAP to select a capacitor

The Second Circuit

Run a Simulation

The Second Circuit: Adding meters

The Second Circuit: Adding meters

Pick a Device: Sinusoidal Voltage Source (VSINE)

Type Vsine to search for a sinusoid voltage source

Double click on VSINE to select a VSINE

Notice the VSINE in the Object Selector

The Third Circuit: Resistive Circuit Response To AC

The Fourth Circuit: RC Response To AC

The Fourth Circuit: RC Response To AC

The Fifth Circuit: DC Amplifier using 741 OpAmp

The Fifth Circuit: Current Source Properties

The Sixth Circuit: AC Amplifier using 741 OpAmp

The Fifth Circuit: Voltage Source Properties