View
1
Download
0
Category
Preview:
DESCRIPTION
sample proposal
Citation preview
INTRODUCTION:World being running out of resources needs maximum recycling of our waste product. Using very simple and common household items we can make decoration models etc which not only brings out our hidden creativity but also is economical .The idea behind our model is based on the same concept. Inspired by our own field we decided to create a car model made out of scrap in different shapes, sizes and styles. The perk of this model is that it is driven by the thrust of air coming out of a balloon. It can make a nice and interesting toy for a child and a unique kind of decoration piece.PRODUCT DETAILS:The analysis of the proposed car model will be made on following factors:
Required Components
Availability of Material
Preparation Methodology
Life of Product
Time Required for Preparation of One Piece
Ease of Creation
Money Matters
ANALYSIS AND PRODUCT DESCRIPTIONI. COMPONENTS:The required components are as follows:
Plastic bottles
Glue
Transparent tape
Bottle caps
Air balloons
Broom sticks
Straws
Card board
Hammer
Nail
Scissor
II. MATERIAL AVAILABILITY: As mentioned, all the material required for making car model is easily available all the time.
III. STEPS FOR PREPARATION: Tape a balloon over one side of a straw so that you can blow from the other end
Take four bottle caps and make holes in the centre of each cap with the help of hammer and nail
Take two broom sticks and pass them through the two bottle caps each to make axle and tyre mechanism
Now join the axles at the base of plastic bottle using transparent tape.
Create a hole on the top of bottle and pass through the straw with the balloon on the other side of it
Use cardboard and disposable glass to decorate the model.
IV. PRODUCT LIFE: Since it is made of plastic bottle, the possibility of damage to the car model is considerably less. If used with care, it can sustain through larger time compared with that of glass ones purchased from markets.
V. TIME FACTOR:
Approximately time required to make one car model is 30 minutes.
VI. MONEY MATTERS: The brief analysis of the expenditure of each product is below:
ComponentPrice (in PKR)
straws30/-
Plastic bottles05/-
Transparent Tape05/-
balloon10/-
glue20/-
Total Amount70/-
We know that 70-Rs is way cheaper than the decorations and gifts we buy from market.TITLE: PROPOSAL FOR CAR MODEL
GROUP MEMBERS: RASHID AZIZ (12-ME-04)
USMAN TARIQ (12-ME-01)
ZAIN-UL-ABIDEEN (12-ME-52)
GOHAR ALTAF (12-ME-70)
AHSAN KHALEEQ (12-ME-184)
MUHAMMAD ABID (12-ME-174)
SUBMITTED TO:
MADAM TEHMINA
DEPARTMENT OF MECHANICAL ENGINEERING UET TAXILA
Recommended