PowerPoint Presentation · Metrology 2. Design of a curing and collaring press for CIEMAT 3. HTS...

FTEC 2018 Progress Status Workshop

CRISTINA CASTRO SEQUEIRO

May 2020

TE – MSC – MDTMagnet Design and Technology

REF279F Mechanical Engineer working on the Dimensional Control of Nb3Sn Coils and Magnet Assemblies

Supervisor: Juan Carlos Pérez

Tasks

1. Metrology2. Design of a curing and collaring press for CIEMAT3. HTS program webpage4. Heavy tooling control upgrade

2

1. Metrology

MQXFS coil

FaroArm

Coil Magnet

Measured deviations of coil cross sections

3

1. Metrology

FaroArm

eRMC assembly

4

1. Metrology

FARO ScanArm

HEPDipo cable

Deviations color map

5

• Scanning of cable sections during winding tests in order to detect and quantify possible deformations.

1. Metrology

Vertical Tower

Collared coils calibration piece

Diameter measurement

Probes

6

Tasks

1. Metrology2. Design of a curing and collaring press for CIEMAT3. HTS program webpage4. Heavy tooling control upgrade

7

Analytical calculations

3D Design with CATIA

Mechanical validation with

ANSYS

Technical specification document

2. Design of a curing and collaring press for CIEMAT

Drawings with CATIA

Validated module design

8

3D design of press structure

• The module structure had to be redesigned in order to accomplish the mechanical requirements.

Tasks

1. Metrology2. Design of a curing and collaring press for CIEMAT3. HTS program webpage4. Heavy tooling control upgrade

9

3. HTS (High Temperature Superconductors)program webpage

10

• Software used in the development:

Tasks

1. Metrology2. Design of a curing and collaring press for CIEMAT3. HTS program webpage4. Heavy tooling control upgrade

11

3. Heavy tooling control upgrade

• Modification of the control of the

927 laboratory curing press

12

THANK YOU FOR YOUR ATTENTION