View
6
Download
0
Category
Preview:
Citation preview
INDUSTRIAL WIRELESS AUTOMATION©2014 OleumTech Corporation. All rights reserved. BreeZ is a registered trademark of OleumTech Corporation. Speci�cations, design, and product descriptions subject to change without notice. Document ID: 67-1002-001e
19762 Pauling, Foothill Ranch, CA 92610Toll-Free (866) 508-8586Phone: (949) 305-9009
Fax: (949) 305-9010Sales@OleumTech.comwww.OleumTech.com
INDUSTRIAL WIRELESS AUTOMATION
PLACE
POSTAGE
HERE
Mail To:
WIRELESS OILFIELD AUTOMATION
CONTROL PANEL∙ RS232 or RS485 Serial Interface with Modbus Master / Slave Function∙ Point-to-Multipoint Networking with End Nodes (Transmitter & I/O Modules)∙ Peer-to-Peer Networking with Other Gateways (Data Sharing & Control)∙ Onboard I/O & I/O Expandable
WELLHEAD∙ Tubing / Casing / Surface / Flowline Pressure∙ Arrival Sensor∙ Valve Control∙ Chemical Pump∙ Plunger Lift
COMPRESSOR∙ Pressure∙ Temperature∙ On / O� Status∙ Panel Data (Modbus)
PRODUCTION TANKS∙ Continuous Level Product / Interface / Temperature∙ Magnetostrictive / Hydrostatic / Resistive∙ High Level Alarm: Top or Side
FLARE STACK∙ Flare Monitoring∙ Temperature∙ Thermocouple
CHEMICAL TANK∙ Level
ADDITIONAL APPLICATIONS∙ Cathodic Protection Monitoring
SEPARATOR∙ Flow∙ High-Level Alarm∙ Pressure∙ Temperature
WIRELESS MULTI I/O∙ Analog Inputs 0-5 V / 0-10 V / 4-20 mA∙ Digital Inputs and Outputs∙ Modbus Master
OleumTech.com ©2014 OleumTech Corporation. All rights reserved.
900 MHz or 2.4 GHz, Point-to-Point, Connect to Gateway
Connect to Base Unit Wireless Gateway
Analog OutputModule WM3000-001
· 4x Analog Outputs 1-5 V (3-Wire)/4-20 mA (2-Wire) Selectable Modes,12-Bit ADC
· 12-24 VDC Power Input
Digital I/O Module WM3000-003
· 8x Programmable Digital Channels· 1 A Sink Current for Open-Drain Outputs· Configurable Debounce Filter· 6-24 VDC Power Input
Wireless Multi-I/O ModuleWM5000-002
· 4x Analog Inputs 0-5 V,0-10 V, or 4-20 mA Selectable Modes, 24-Bit ADC
· 4x Programmable Digital Channels· 9-30 VDC Power Input· RS485 I/O Expansion Port (RJ-45)
WIRELESS I/O EXPANSION MODULES
WIRED I/O EXPANSION MODULES
900 MHz or 2.4 GHz, Point-to-Multipoint, Peer-to-Peer
Base UnitWM2000-002
· RS232 or RS485 Serial Interface (Modbus Master / Slave Function)
· 4x Analog Inputs 0-5 V· 2x Digital Inputs + 2x Digital Outputs· RS485 I/O Expansion Port (RJ-45)· 9-24 VDC Power Input
DH2SR5000-DH2
· RS232 or RS485 Serial Interface (Modbus Master / Slave Function)
· 9-24 VDC Power Input
Wireless Digital I/O Module WM5000-004
· 6x ProgrammableDigital Channels
· 30 VDC (Max) Input for All Channels· 1 A Sink Current for Open-Drain Outputs· Configurable Debounce Filter· 9-30 VDC Power Input
Wireless AnalogInput ModuleWM5000-003
· 4x Analog Inputs 0-5 V, 0-10 V, or 4-20 mA
· Selectable Modes, 24-Bit ADC· 9-30 VDC Power Input
Analog Input ModuleWM3000-002
· 4x Analog Inputs 0-5 V, 0-10 V, or4-20 mA Selectable Modes, 24-Bit ADC
· 6-24 VDC Power Input
The patented Wireless System is comprised of Wireless
Transmitters, Wireless Gateways, I/O Expansion Modules, and
user-friendly BreeZ® Software. The Wireless System is a highly
reliable, scalable, �exible, and manageable solution that is ideal
for operation in remote and/or hazardous locations.
Wireless Transmitters: We o�er a comprehensive line of
transmitters for wirelessly monitoring various conditions
including liquid level, high level, pressure, �ow, temperature, and
triggering alarm. Our Wireless Transmitters are self-contained and
battery-powered, eliminating the need for external power.
Additionally, these devices are intrinsically safe for use in Class I,
Division 1 locations, while providing seamless integration with
third-party devices and sensors. The new WT series products
feature a local LCD display. This feature enables con�guring
device on-site without cables and allows instant readings without
connecting to a PC.
Wireless Gateways: We o�er two versions: Base Unit and
DH2. These Gateways collect data from end nodes in a
point-to-multipoint fashion. The collected data is exchanged with
backbone SCADA systems via Modbus (RS232/RS485 Serial Interface).
Additionally, multiple Gateways can be added to the same network
for peer-to-peer data sharing: mirror I/O, valve control, Emergency
Shut Down (ESD), and much more.
I/O Expansion Modules: These devices are o�ered in both
Wireless and Wired versions for expanding various I/O capabilities
to a network: both analog and discrete.
The Wireless devices are managed with the BreeZ® Software. It allows users to easily and quickly create a network, add devices
to a network, de�ne parameters and set transmission intervals for
each device using a PC.
OleumTech is a leading provider of wireless automation
solutions for industrial applications involving process monitoring
and control systems. Our products unite traditional control
infrastructures with cutting-edge wireless technology and
enables organizations to improve operational e�ciency and
productivity, reduce cost and meet regulatory compliance
requirements.
Since 2002, OleumTech has been committed to the needs of
mission-critical wireless automation applications in the Oil & Gas,
Re�ning, Petro-Chemical, Utilities, Water/Wastewater industries,
and many others.
INDUSTRIAL WIRELESS AUTOMATION
COMPANY PROFILE
Help Meet RegulatoryCompliance
Gain CompetitiveAdvantage
Improve OperatorSafety
Reduce OperatingCost
Rapid Implementation
WIRELESS GATEWAYS
ISO9001
OleumTech
REGISTERED COMPANY
ISO9001
Man
ufac
tu
ring
Support Engineering
Sales & Marketing Application
R&D
and
Continuous Customer
Techni
cal
Improvem
ent Service
Suppor
t
Base Unit Connected to I/O Expansion Modules via RS-485
· Set-Point Level Detection· Includes Level Switch Shown· Mounts on Side of Tank
High Level Switch Transmitter - SideWT-0900-HL2
· Set-Point Level Detection· 1 or 2 Actuation Points for High & High-High Level· Switch Length Up to 6 ft. (Custom Lengths Also Available)· Mounts on Top of Tank
High Level SwitchTransmitter - Top WT-0900-HL1
WIRELESS TRANSMITTERS 900 MHz or 2.4 GHz, Battery-Powered, Point-to-Point, Up to 7500 ft. Range (900 MHz)
LCD WIRELESS TRANSMITTERS900 MHz or 2.4 GHz, Battery-Powered, Point-to-Point, Up to 7500 ft. Range (900 MHz)
High Level SwitchTransmitter - Top
· Set-Point Level Detection· 1 or 2 Actuation Points for High & High-High Level· Switch Length Up to 6 ft. (Custom Lengths Also Available)· Mounts on Top of Tank
· Monitors Flare, Kilns, Gas Turbine, etc.· Supports Thermocouple Sensor Type K· Compatible with Third-Party Sensors· Units in US or Metric· Provides Wiring Board
ThermocoupleTransmitter SM5000-TC1
· Monitors On/Off, Open/Closed Status, or Alarm Conditions· 2x Discrete Inputs· Open-Drain or Dry Contact (NPN)· DS1: Flying Leads / No Junction Box· DJ1: Includes Junction Box
DiscreteTransmitter SM5000-DS1SM5000-DJ1
H-SERIES HARDWIRED SENSOR
· High Resolution Magnetostrictive· Product, Interface & Temperature Levels· Rigid / Flex / Ultra-Flex Sensor· Single or Dual Float· Standard or Large Float Size
Liquid Level SensorHW5000-LS1 (Modbus)HW5000-LS2 (LevelMaster ASCII)
Shown with Rigid Sensor - 316 SS
Hydrostatic LevelTransmitter LM5000-HP1
· Low-Cost Liquid Level Solution· For Vented Tanks and Wells· Custom Lengths Available up to 70 ft.
AnalogTransmitter SM5100-P01SM5100-P02SM5100-P04
· 1, 2, or 4x Analog Input Option· 0-5 V, 24-bit ADC· Flying Leads· Junction Box Optional
· Product, Interface & Temperature Levels· High Resolution Magnetostrictive· Rigid / Flex / Ultra-Flex Sensor· Single or Dual-Float· Standard or Large Float Size
Digital Level Transmitter LM5000-WDG
RTD TemperatureTransmitter SM5000-RTDSM5000-RTM
· Monitors Air, Gas, Water, or Liquid Temperatures· Supports All Platinum 100 Ohm Sensors· RTD (Direct Mount): Includes Sensor· RTM (Multi-Vendor): Includes Junction Box
Shown with Rigid Sensor withLarge Floats & High Level Switch
Liquid Level TransmitterMagnetostrictiveWT-0900-LL2
· Product, Interface & Temperature Levels· Rigid / Flex / Ultra-Flex Sensor· Single or Dual Float· Standard or Large Float Size· Includes Junction Box for Wiring· 2x Discrete Inputs
· 1x Analog Input (0-5 V, 24-Bit ADC) · LL4 (Direct-Mount): Includes Sensor & 1.5” NPT Male Adjustable Compression Fitting· LL5 (Multi-Vendor Version): Includes Junction Box & Strain Relief Solution
Liquid Level TransmitterHydrostaticWT-0900-LL4WT-0900-LL5
SM5000-HLT
· Same Features as WDG, but with Quick Connect Adapter· No Wiring Involved
Digital LevelTransmitterQuick Connect LM5000-WDG-QC
· 3x Analog Inputs (0-5 V, 24-Bit ADC)· 1x Discrete Input (For Dry-Contact or Open-Drain Output Device)· Allows Zero and Max Callibration· Includes 1/2” Reducing Bushing· Provides Terminal Block for Easy Wiring
Analog/PressureTransmitter WT-0900-AD1
· Non-Contact Level Monitoring Solution· 1 ft to 12 ft Level Reading Range· Includes Sensor· Includes 1.5” NPT Male Adjustable Compression Fitting
Liquid Level TransmitterUltrasonicWT-0900-LL6
· 2x Discrete Inputs On/Off, Open/Closed, or Alarm· Normally Open or Closed Input Function· On-Delay Exception Reporting· Direct or Pipe-Mount Version· Provides Terminal Block for Easy Wiring
DiscreteTransmitter WT-0900-DS1
· Monitors Flare, Kilns, Gas Turbine, etc.· Supports Thermocouple Sensor Type K· Compatible with Third-Party Sensors· Provides Wiring Board· Units in US or Metric
Transmitter WT-0900-TC1
Thermocouple
· Monitors Air, Gas, Water, or Liquid Temperatures· Supports 2, 3, or 4-Wire Sensor· Direct Mount (Includes Sensor) or Multi-Vendor
RTD TemperatureTransmitter WT-0900-RT1 (Direct Mount)WT-0900-RT2 (Multi-Vendor)
· High-Speed Pulse Counter (1 Hz-10 kHz)· Compatible with Third-Party Turbine Meters· Captures Today’s, Yesterday’s, and Raw Totals· Calculates Instantaneous Rate
Flow TotalizerTransmitter WT-0900-FT1
Quick Connect Eliminates Wiring and Junction Box
Shown withUltra-Flex Sensor
PressureTransmitter SM5000-JP1SM5000-JP2SM5000-JP4
· 1, 2, or 4x Pressure Input Option· Compatible with Third-Party Pressure Transducers· 0-5 V, 24-bit ADC· Flying Leads / Includes Junction Box
Cathodic ProtectionTransmitter
· Monitors Cathodic Protection Integrity· Current Range: 0-20, 0-40, or 0-80 A· 0-50 V DC Input for Monitoring Cathodic Rectifier DC Voltage Output· Provides Terminal Block for Easy Wiring· Includes DC Current Sensor
SM5000-CP1
High Level SwitchTransmitter - Side
· Set-Point Level Detection· Includes Level Switch Shown· Mounts on Side of Tank
SM5000-HLS
Liquid Level TransmitterMagnetostrictiveQuick ConnectWT-0900-LL1
· Product, Interface & Temperature Levels· Rigid / Flex / Ultra-Flex Sensor· Single or Dual-Float· Standard or Large Float Size· Quick Connect· No Wiring Involved
LL4 Shown
Shown withUltra-Flex Sensor
Recommended