Phillips Head Screwdriver - pcilube.com · CAF2090 Tools Required Phillips Head Screwdriver...

CAF2090

Tools RequiredPhillips Head Screwdriver

Applications

©2014 ~ Mighty Distributing System of America ~ 650 Engineering Drive, Norcross, GA 30092

1 2

3b

4

Open glove box.Remove the 8 glove box housing screws.

"Instructions are provided as general guidelinesand may not provide every necessary detail for proper removal and installation. Please consult your specific vehicle's owner's or repair manual for additional information."

Revised Nov-14

20 Minutes

ReplacementTime

Under glove box

Location

Remove the side cover from the edge of the glove box assembly.

3a

3c

AirVent

Remove the used filter by pulling on the small tab (if present) on the filter.Tip: Compress filter.

Reverse procedure to complete installation.

Locate filter inside the housing unit.

Tip: Compress filter.

56

Air Vent Compress

Filter

Air Vent

Remove the glove box assembly (3a).Disconnect glove box lamp (3b).Look behind and below this bracket to access the filter housing cover (3c).

Locate and unclip filter housing cover.Tip: Note the air vent near the bracket.

2012-2007 Nissan Altima2014-2009 Nissan Maxima2014-2009 Nissan Murano2014-2011 Nissan Quest