View
214
Download
0
Category
Tags:
Preview:
Citation preview
P461 - Semiconductors 1
Superconductivity
• Resistance goes to 0 below a critical temperature Tc
element Tc resistivity (T=300)
Ag --- .16 mOhms/m
Cu -- .17 mOhms/m
Ga 1.1 K 1.7 mO/m
Al 1.2 .28
Sn 3.7 1.2
Pb 7.2 2.2
Nb 9.2 1.3
• many compounds (Nb-Ti, Cu-O-Y mixtures) have Tc up to 90 K. Some are ceramics at room temp
Res.
T
P461 - Semiconductors 2
Superconductors observations
• Most superconductors are poor conductors at normal temperature. Many good conductors are never superconductors
superconductivity due to interactions with the lattice
• practical applications (making a magnet), often interleave S.C. with normal conductor like Cu
• if S.C. (suddenly) becomes non-superconducting (quenches), normal conductor able to carry current without melting or blowing up
• quenches occur at/near maximum B or E field and at maximum current for a given material. Magnets can be “trained” to obtain higher values
P461 - Semiconductors 3
Superconductors observations
• For different isotopes, the critical temperature depends on mass. ISOTOPE EFFECT
• again shows superconductivity due to interactions with the lattice. If M infinity, no vibrations, and Tc 0
• spike in specific heat at Tc
• indicates phase transition; energy gap between conducting and superconducting phases. And what the energy difference is
• plasma gas liquid solid superconductor
M
KE
SntconsTM
vibrations
c
)(tan 119,117,1155.0
P461 - Semiconductors 4
What causes superconductivity?
• Bardeen-Cooper-Schrieffer (BCS) model
• paired electrons (cooper pairs) coupled via interactions with the lattice
• gives net attractive potential between two electrons
• if electrons interact with each other can move from the top of the Fermi sea (where there aren’t interactions between electrons) to a slightly lower energy level
• Cooper pairs are very far apart (~5,000 atoms) but can move coherently through lattice if electric field resistivity = 0 (unless kT noise overwhelms breaks lattice coupling)
electronelectron
atoms
P461 - Semiconductors 5
Conditions for superconductivity
• Temperature low enough so the number of random thermal phonons is small
• interactions between electrons and phonons large ( large resistivity at room T)
• number of electrons at E = Fermi energy or just below be large. Phonon energy is small (vibrations) and so only electrons near EF participate in making Cooper pairs (all “action” happens at Fermi energy)
• 2 electrons in Cooper pair have antiparallel spin space wave function is symmetric and so electrons are a little closer together. Still 10,000 Angstroms apart and only some wavefunctions overlap (low E large wavelength)
P461 - Semiconductors 6
Conditions for superconductivity 2
• 2 electrons in pair have equal but opposite momentum. Maximizes the number of pairs as weak bonds constantly breaking and reforming. All pairs will then be in phase (other momentum are allowed but will be out of phase and also less probability to form)
• if electric field applied, as wave functions of pairs are in phase - maximizes probability -- allows collective motion unimpeded by lattice (which is much smaller than pair size)
021 ppPpair
rpie
221
2 |....||| ntotal
different times
different pairs
P461 - Semiconductors 7
Energy levels in S.C.• electrons in Cooper pair have energy as part of the Fermi sea (E1 and
E2=EF plus from their binding energy into a Cooper pair (V12)
• E1 and E2 are just above EF (where the action is). If the condition is met then have transition to the lower energy superconducting state
• can only happen for T less than critical temperature. Lower T gives larger energy gap. At T=0 (from BCS theory)
122121 VEEE
FEE 221
normal
s.c.12
2
E
EF
CT
Temperature
Egap
Cgap kTE 3
P461 - Semiconductors 8
Magnetic Properties of Materials
• H = magnetic field strength from macroscopic currents• M = field due to charge movement and spin in atoms -
microscopic
• can have residual magnetism: M not equal 0 when H=0• diamagnetic < 0. Currents are induced which counter
applied field. Usually .00001. Superconducting = -1 (“perfect” diamagnetic)
vectorscalarHTbecan
litysusceptibimagneticHM
MHB
,),(),(:
)(0
P461 - Semiconductors 9
Magnetics - Practical• in many applications one is given the magnetic properties of a
material (essentially its ) and go from there to calculate B field for given geometry
D0 Iron Toroid
beamline sweeping magnet
spectrometer air-gap analysis
magnet
P461 - Semiconductors 10
Paramagnetism• Atoms can have permanent magnetic moment which
tend to line up with external fields
• if J=0 (Helium, filled shells, molecular solids with covalent S=0 bonds…) = 0
• assume unfilled levels and J>0 n = # unpaired magnetic moments/volume n+ = number parallel to B n- = number antiparallel to B n = n+ + n-
• moments want to be parallel as
Femost 54 10,10
)(
)(
parallelB
elantiparallB
BE
P461 - Semiconductors 11
Paramagnetism II• Use Boltzman distribution to get number parallel and
antiparallel
• where M = net magnetic dipole moment per unit volume
• can use this to calculate susceptibility(Curie Law)
)(
/
/
nnM
nCen
nCenkTB
kTB
kT
B
kTBkTB
kTBkTB
ktBifee
ee
n
Maverage
kTBkTB
kTBkTB
2
//
//
)/1()/1(
)/1()/1(
kT
n
kTH
Bn
H
n
H
M
smallHMHB2
02
000 )(
P461 - Semiconductors 12
Paramagnetism III• if electrons are in a Fermi Gas (like in a metal) then
need to use Fermi-Dirac statistics
• reduces number of electrons which can flip, reduces induced magnetism, smaller
ne
Cn
ne
Cn
kTEB
kTEB
F
F
1
11
1
/)(
/)(
antiparallel
parallel
EF
FEkTB 0
turn on B field. shifts by B
B2
antiparallel states drop to
lower energy parallel
P461 - Semiconductors 13
• Certain materials have very large (1000) and a non-zero B when H=0 (permanent magnet). will go to 0 at critical temperature of about 1000 K ( non ferromagnetic)
4s2: Fe26 3d6 Co27 3d7 Ni28 3d8 6s2: Gd64 4f8 Dy66 4f10
• All have unfilled “inner” (lower n) shells. BUT lots of elements have unfilled shells. Why are a few ferromagnetic?
• Single atoms. Fe,Co,Ni D subshell L=2. Use Hund’s rules maximize S (symmetric spin) spatial is antisymmetric and electrons further apart. So S=2 for the 4 unpaired electrons in Fe
• Solids. Overlap between electrons bands but less overlap in “inner” shell overlapping changes spin coupling (same atom or to adjacent atom) and which S has lower energy. Adjacent atoms may prefer having spins parallel. depends on geometry internuclear separation R
Ferromagnetism
P461 - Semiconductors 14
• R small. lots of overlap broad band, many possible energy states and magnetic effects diluted
• R large. not much overlap, energy difference small
• R medium. broadening of energy band similar to magnetic shift almost all in state
Ferromagnetism II
vs
FE
FE
FE
P A
P A
vs
R
E(unmagnetized)-
E(magnetized)
Mn
Fe Co Ni
Recommended