OneTwoThree FourFiveSix SevenEightNine End Click on the arrow below to continue
Preview:
Citation preview
- Slide 1
- Slide 2
- Slide 3
- OneTwoThree FourFiveSix SevenEightNine End
- Slide 4
- Click on the arrow below to continue.
- Slide 5
- Click on the arrow below and try again
- Slide 6
- Click on the arrow below and try again
- Slide 7
- Click on the arrow below and try again
- Slide 8
- Click on the arrow below and try again
- Slide 9
- Click on the arrow below and try again
- Slide 10
- Click on the arrow below and try again
- Slide 11
- Click on the arrow below and try again
- Slide 12
- Click on the arrow below and try again
- Slide 13
- Click on the arrow below and try again
- Slide 14
- Which alignment angle is NOT adjustable? 1. Camber Camber 2.
Caster Caster 3. Steering Axis Inclination Steering Axis
Inclination
- Slide 15
- Front wheel toe is adjusted by using. 1. Shims Shims 2. Tie rod
sleeves Tie rod sleeves 3. Adjustment cams Adjustment cams
- Slide 16
- The three major components of the steering system are: Steering
column, steering gear and 1. Steering hanger beamSteering hanger
beam 2. Steering linkageSteering linkage 3. Steering toeSteering
toe
- Slide 17
- An adjusting sleeve is attached to the. 1. Tie rod Tie rod 2.
Idler arm Idler arm 3. Pitman arm Pitman arm
- Slide 18
- When the rear of the front tires are closer together than the
front, the steering has. 1. Bent parts Bent parts 2. Positive scrub
radius Positive scrub radius 3. Toe out Toe out
- Slide 19
- Unsprung weight is the weight of the. 1. Wheels, tires and
moving parts of the suspension. Wheels, tires and moving parts of
the suspension. 2. Vehicle, minus the wheels, tires and moving
parts of the suspension. Vehicle, minus the wheels, tires and
moving parts of the suspension. 3. Vehicle, without any
load/passengers. Vehicle, without any load/passengers.
- Slide 20
- McPherson strut suspensions use what type of springs? 1. Leaf
Leaf 2. Torsion bar Torsion bar 3. Coil Coil
- Slide 21
- Backward and forward tilt of the spindle support is referred to
as? 1. Camber Camber 2. Steering axis inclination Steering axis
inclination 3. Caster Caster
- Slide 22
- Inward or outward tilt of the front wheels is referred to as?
1. Camber Camber 2. Steering axis inclination Steering axis
inclination 3. Caster Caster
- Slide 23
- You are ready for the test!