NP4-12 Data Sheet - JPR Electronics · NP SERIES - NP4-12 Data Sheet Lead Calcium Grids The heavy...

Reliability is your SecurityYuasa NP, NPC and NPH Batteries. Utilising thelatest advance design Oxygen RecombinationTechnology, Yuasa have applied their 80 yearsexperience in the lead acid battery field to producethe optimum design of Sealed Lead Acid batteries.

FEATURES• Superb recovery from deep discharge.• Electrolyte suspension system.• Gas Recombination.• Multipurpose: Float or Cyclic use.• Usable in any orientation (except continuous inverted).• Superior energy density.• Lead calcium grids for extended life.• Manufactured World wide.• Application specific designs.

Technical FeaturesSealed ConstructionYuasa’s unique construction and sealing techniqueensures no electrolyte leakage from case or terminals

Electrolyte Suspension SystemAll NP batteries utilize Yuasa’s unique electrolytesuspension system incorporating a microfine glass mat toretain the maximum amount of electrolyte in the cells. Theelectrolyte is retained in the separator material and thereis no free electrolyte to escape from the cells. No gels orother contaminants are added.

Control of Gas GenerationThe design of Yuasa’s NP batteries incorporates the verylatest oxygen recombination technology to effectivelycontrol the generation of gas during normal use.

Low Maintenance OperationDue to the perfectly sealed construction and therecombination of gasses within the cell, the battery isalmost maintenance free.

Terminals

Layout

NPwww.yuasa-battery.co.uk

DDaattaa SShheeeettNP SERIES - NNPP44--1122

NP4-12

4

3.7

3.4

2.4

12

75

27

40

40/75

120

90

70

106

1.75

A/D

1

-

20hr to 1.75vpc 30ºC

10hr to 1.75vpc 20ºC

5hr to 1.70vpc 20ºC

1hr to 1.60vpc 20ºC

Voltage

Energy Density (Wh.L.20hr)

Specific Energy (Wh.kg.20hr)

Int. Resistance (m.Ohms)

Maximum discharge (A)

Short Circuit current (A)

Dimensions (mm)

Length

Width

Height overall

Weight (Kg)

Terminal

Layout

Terminal Torque Nm

GeneralSpecificationsNominal Capacity (Ah)

TerminalsNP batteries are manufactured using a range of terminalswhich vary in size and type. Please refer to details asshown.

Operation in any OrientationThe combination of sealed construction and Yuasa’sunique electrolyte suspension system allows operation inany orientation, with no loss of performance or fear ofelectrolyte leakage. (Excluding continuous use inverted)

Valve Regulated DesignThe batteries are equipped with a simple, safe lowpressure venting system which releases excess gas andautomatically reseals should there be a build up of gaswithin the battery due to severe overcharge. Note. On noaccount should the battery be charged in a sealedcontainer.

.059

.185 ± .004

.124

.098

.250

.020

.031

Faston tab: 187 A

INCH = MM.250 6.35.185 4.70.124 3.15.098 2.50.059 1.50.031 0.80.020 0.50.004 0.10

.310

± .0

08 .16

.250 ± .004 .020

.031 ± .004

Faston tab: 250 D

INCH = MM.310 7.90.250 6.35.16 4.0.031 0.8.020 0.5

NPwww.yuasa-battery.co.uk

DDaattaa SShheeeettNP SERIES - NNPP44--1122Lead Calcium GridsThe heavy duty lead calcium alloy grids provide an extramargin of performance and life in both cyclic and floatapplications and give unparalleled recovery from deepdischarge.

Long Cycle Service LifeDepending upon the average depth of discharge, over athousand discharge/charge cycles can be expected.

Float Service LifeThe expected service life is five years in float standbyapplications.

SeparatorsThe use of the special separator material provides a veryefficient insulation between plates preventing inter-plateshort circuits and prohibiting the shedding of activematerials.

Long shelf LifeThe extremely low self discharge rate allows the battery tobe stored for extended periods up to one year at normalambient temperatures with no permanent loss of capacity.

Operating Temperature RangeThe batteries can be used over a broad temperature rangepermitting considerable flexibility in system design andlocation.Charge – 15°C to 50°CDischarge – 20°C to 60°CStorage – 20°C to 50°C (fully charged battery)

CYCLIC RECHARGE REGIME

SELF DISCHARGE CHARACTERISTICS

FLOAT SERVICE LIFE NP RANGE

TYPICAL DISCHARGE CHARAC-TERISTICS NP RANGE

NP DISCHARGE CHARACTERISTICSCURVES AT 25ºC (77ºF)

FLOAT CHARGE CHARACTERISTICS

Distributed byYuasa Battery Sales (UK) Ltd

Unit 22 Rassau Industrial EstateEbbw Vale, Gwent, NP23 5SD

Tel: 08708 500312 Fax: 08708 500317E-mail: enquiries@yuasa-sales.co.uk

Registered number 1548820

Cat. No. NP4-12 February 07

E&O.E.

www.yuasa-battery.co.uk

DDaattaa SShheeeettNP SERIES - NNPP44--1122INTELLIGENT BATTERY CHARGERSManufactured to BS3456, IEC335, UL 1236,EN60335, CE mark to EN5008-1

FeaturesMicro processor controlledShort circuit protectionReverse polarity protectionHigh temperature protectionSoft start current controlFast constant current bulk charge3 stage charging CI-CV-floatConstant voltage float/standbyProportional timingFlexibility, to match battery specification.

Standard RangeYCP03A12 300mA 12vYCP03A24 300mA 24vYCP03A6 300mA 6vYCP06A12 600mA 12vYCP06A6 600mA 6vYCP1.5A12 1.5A 12vYCP1.5A24 1.5A 24vYCP1.5A6 1.5A 6vYCP1A12 1A 12vYCP1A6 1A 6vYCP2A12 2A 12vYCP2A24 2A 24vYCP2A6 2A 6vYCP3A12 3A 12vYCP4A12 4A 12vYCP6A12 6A 12vYCP8A12 8A 12vYCP10A12 10A 12vYCP8A24 8A 24v

Standard NPAvailable in a wide range of sizes to suit general applications.

NPH/NPWHigh performance batteries specially designed for applications requiringhigh rate discharge, supplying up to 50% (NPH), (NPW) more power(Watts) for short durations when compared to conventional NP models.

NPCSpecifically designed to suit the arduous requirements of cyclicapplications allowing increased cycle life (at least double that ofconventional types). (NPC Shortform refers)

NPL Long Life Model also to BS6290pt4 (FR Options)Dedicated literature available on request. (NPL Shortform refers).

ApplicationsYuasa NP batteries, having excellent deep discharge recoverycharacteristics coupled with long life on float standby, are ideal fornumerous applications in both cyclic and standby modes. For adviceon the use of NP batteries in your particular application please contactour Sales Office.

Charging For Float Standby ApplicationsCharged at 2.275 volts per cell continuous. The battery will seek its owncurrent level and float fully charged. However, users should be awarethat when charging from fully discharged, the battery can draw an initialcharge current of approximately 2cA. Care should therefore be taken toensure that this initial charge current (if ungoverned) is within theoutput capability of the equipment. Final charge current at 2.275 voltsper cell is typically between 0.0005cA to 0.004cA.

Charging For Cyclic ApplicationsSee cyclic recharge regime graph.

CAUTION- Do not Short Circuit- Do not charge in a sealed container- Service life and operational characteristics will

be affected by temperature- AC Ripple reduces service life.

RELATIONSHIP BETWEENCHARGING VOLTAGE ANDTEMPERATURE

NPH DISCHARGE CHARACTERISTIC CURVES