View
216
Download
0
Category
Preview:
Citation preview
Place the slab roller on a flat surface. Do not operate with more than 2 people.
This is not a toy.Children should not operate.
Make sure the handle is secured properly in place before using.
Do not disassemble. Do not use with extremely stiff clay or any other materials.
Do not put your hands in or near the following parts when in operation; rollers,roller adjustment area and canvas.
Mini Portable Slab Roller:SRM-1624Operation manual
92935C
Thank you for purchasing the Shimpo SRM-1624. Effortlessly create a flat, even slab in any space.
■ Accessories
Main body : 1unit
Handle : 1pc
Canvas : 2sheets
Board : 1 pc
● Dimension : 24" × 27"× 8-1/2" Height
● Weight : 31 lbs
● Maximum slab dimension : 16"× 24" , 0 ~ 1" Thickness
■ Parts List
For your safety
Caution
Handle
Roller
Remove the bolt on the roller
shaft. Then, Insert the handle
and fix it by a bolt.
Thickness Gauge
Canvas
Board
Stabilizer bar
Cam lever
Roller plate
While operating the slab roller
be carefull not to get your
hands or clothes caught in
the rollers.
4. Install the handle into the roller assembly
5. To finish the slab
2. To adjust the thickness of the clay
1. How to set up the portable mini slab roller
3. How to prepare your slab roller to make a clay slab
2.1.
2.2.
4.1.
5.1.
5.2.
3.1.
3.2.
3.3.
Pull up on the cam levers to release the lock on the rollers.
Set the rol lers to the des i r ed th i ckness o f clay by sliding the rollers up or down, fo l lowing the thickness gauge on the inside of the roller assembly.
Turn the handle clockwise
while guiding the board
through the rollers in the
direction of the arrow.
Once the board has been completely rolled through the rollers and is on the right side, roll the board back through(rotat ing handle counter-clockwise) so that it is on the left side again. This means the clay will be rolled through the rollers twice.
Remove the top canvas to reveal a completed slab.
Place one canvas on the board. Then place the board, with the canvas, on the left side of the rollers just between the rollers.
Place a "cheese wedgeshape " p iece of wel l-mixed, soft, clay on the canvas covered board. T h e c l a y should not exceed 1-1/2" in height. The c l a y s hou l d no t exceed the height of the top roller.
Place the second canvas on top of the clay.
1.1 Pull out the metal stabilizer bars on both sides of the
roller assembly.
***Do not use sharp tools when cutting clay on the canvas, this can damage the canvas.
Caution in using Portable slab roller
**Attention: The thickness gauge is just an approximation of thickness.
***Do not overload the slab roller with a lot of clay at once, this can cause damage to the slab roller. ***Clean any leftover clay from canvas.
1701 Glenlake Avenue Itasca,IL60143 USA Phone:(800)237-7079 FAX:(630)924-7639
Stabilizer bar
Recommended