MIC 303 INDUSTRIAL AND ENVIRONMENTAL MICROBIOLOGY

MIC 303INDUSTRIAL AND ENVIRONMENTAL MICROBIOLOGY

MICROBIAL GROWTH KINETICS

Mdm Aslizah Mohd Aris

TYPE OF MICROBIAL GROWTH SYSTEM

3 major type:Batch cultureContinuous or Chemostat CultureFed-batch Culture

BATCHCULTURE

BATCH CULTUREDefinition: A closed system with limited amount of nutrient (no additional of medium added)Cells grows through several phases:i) Lag phaseii) Log phaseiii) Deceleration

phaseiv) Stationary

phasev) Death phase

i) Lag phaseTime of adaptation of cell to the environment or medium (reorganization of micro molecular contituents).Length of lag phase may vary (depend on specific circumstances).Shorter lag time is recommended for industry, can be achieved using suitable inoculum (active or not) and environmental condition.Synthesis or inhibition of the enzyme or cell structure components may occur.Typical effects: Low cell number / cell concentration. No changes in substrate pH. No changes in substrate concentration. No product formation.

ii) Log phaseIllustrate by a linear line of the plot of log cell mass vs time.During this phase, a growth at steady state where specific growth rate, µ are fixed.Cell growth at maximum attainable rate.Typical effects in log phase: Rapid increase in cell concentration. Rapid changes in substrate pH. Substrate concentration decreased. Product formation starts.

iii) Deceleration phaseGrowth rate slowly decreases due to: Consumption of nutrient or essential

nutrient become depleted (substrate limitation). Accumulation of toxic product.

iv) Stationary phase

iv) Death phase

GROWTH VS MULTIPLICATIO

N CURVE

GROWTH CURVE MULTIPLICATION CURVE

A plot of biomass concentration against Incubation time.

A plot of cell number against time.

Lag phase is shorter than the multiplication curve since the growth rate begins to increase earlier than the multiplication rate.

Lag phase longer.

The log phase is substantially longest.

Shorter log phase.

Section 3 of both curve are identical.

Section 3 of both curve are identical.

Death phase sets in earlier. Death phase sets in later.

Stationary phase is much longer. Shorter stationary phase.

COMPARISON BETWEEN GROWTH AND MULTIPLICATION CURVE

GROWTH CURVEX = Biomass concentrationIndividual phases:1: Lag phase2: Accelaration

phase3: Balanced growth4: Deceleration

phase5: Stationary phase6: Death phase

MULTIPLICATION CURVE

N = No of cell Individual phases:1: Lag phase2: Accelaration

phase3: Balanced growth4: Deceleration

phase5: Stationary phase6: Death phase

PRODUCTION KINETICS

To determine the metabolic parameters

Need data on: substrate uptake with time

• with and without product formation product generation with time

• with and without cell growth cell growth with time

Specific growth rate:

Where: dx = Change in biomass concentration.

dt = Change in incubation time.

x = biomass concentration.

Specific growth rate, µ expressed in reciprocal time unit (h-

1).

During batch cultivation, specific growth rate changes continuosly from zero to the max value µmax.

µmax depends on microorganisms, physical, chemical

conditions.Typical values of µmax:

MicroorganismsCultivation

Temperatureµmax (h-1)

Bacteria 37ºC 0.6-1.2

Yeast 30ºC 0.3-0.5

Actinomycetes 28ºC 0.1-0.3

Fungal 28ºC 0.1-0.3

By plotting the growth curve of the microorganisms, then determine the instavenous µ value at each sampling time by ascertaining the tangent at the point of contact on the growth curve.The highest value obtained (from 24-72h) is the µmax.

The Yield Coefficient (Y)A measure of the overall efficiency of the conversion of substrate to cell mass or specific product:

Y is not constant, will vary depending on organism, pH, temperature and substrate

Parameter Equation

Cell (Y x/s) ΔX / ΔS

Product (Y p/s) ΔP / ΔS

Product (Y p/x) ΔP / ΔX

Substrate Utilization and Product Formation (Yp/s)

YP/S =g/l product producedg/g carbon sources utilized

= g/g

Economic yield (Yp/x)

YP/X =g/l product producedg/L biomass formed

= g/g

Batch ProductivityProductivity – a measure of product ( or biomass) produced per unit time (g/L/h).Product formation of growth – link product is closely related with growth rate.Productivity in batch culture will be a greatest when growth rate max (µmax).

Productivity (R batch) =

X max - Xo

T final – T initial

Where;X max = maximum cell concentration at stationary phase

Xo = initial cell during inoculation

T final = time during which organism growing at µmax

T initial = time which organism not growing at µmax, including lag phase, deceleration phase period of batching, sterilizing and so on.

Incubation Time (h)

dt 1/t [Cell] (g/L)

dx 1/x dx/dt µ (h-

1)

0 0

24 0.042 0.1 0 0.004 0

24 0.1

48 0.021 0.2 10.0 0.004 0.04

48 0.2

72 0.014 0.3 5.0 0.004 0.021

72 0.3

96 0.3 3.33

96 0.3

120

120 0.2

144

144 0.1

168

168 0.05

192

192 0.02

CONTINUOUS CULTURE

CONTINUOUS CULTUREFresh fermentation media is continuosly added to the reactor while fermenter broth containing biomass, products and unused nutrient are continuosly removed.Exponential growth in batch culture may be prolonged by the addition of fresh medium to the vessel.Growth can be maintained for long durationContinuous feeding to a culture at a suitable rate formation of new biomass by the culture is balanced by the loss of cell from the vessel STEADY STATE.

Application of Continuous Culture

Biomass productionGrowth associated product or primary metabolite – e.g: ethanol, citric acidNot suitable for non-growth associated or secondary metabolite – e.g: antibiotic

ImportantWhen referring to continuous culture systems, the terms used in batch culture (lag, exponential, stationary, death phase)

have no meaning because the system is operating continuously and growth cannot segregated into phases

BATCH CULTURE CONTINUOUS CULTURE

Nutrients added only at start Nutrients added continuously

Product removed when fermentation stops.

Product continuously removed .

Growth rates and product formation are slower because limiting factors ex: substrate levels/ build up of toxins.

Organism held in exponential growth phase giving higher productivity so can be on a smaller scale.

Slower growth rates = Larger vessels are used.

Easy to set up and maintain. Can be very difficult to maintain conditions so that exponential phase is maintained. Foaming, clumping and blocked inlet pose problems.

If contamination occurs only one batch is wasted.

Contamination can afferct a huge volume of product/ organism.

Less efficient / more time wasted shutting down removing product and starting up again.

Continuous, therefore more efficient use of time.

Product quality can vary between batches.

Product quality more consistent.

FED-BATCHCULTURE

FED BATCH CULTUREExtending the batch culture by feeding continuously or periodically with medium with no removal of culture from the vessel.Somewhere between batch and continuous culture.A volume of medium is inoculated with the organism and allowed to grow for a batch period of time.Subsequently, a feed is initiated into the fermenter when a “quasi steady state” is obtained.Quasi steady state: when the growth limiting substrate has depleted.

PRODUCT FORMATION

Production kinetics

Classified based on the relationship between product synthesis and energy generation in the cell Growth associated. Non-growth associated. Mixed-growth associated.

ProductsGrowth-associated. produced at the same time as cell growth.

• constitutive enzymes (ones that are normally present). glucose isomerase.

• metabolic intermediates. pyruvate, citrate, acetate.

Non-growth-associated. takes place during the stationary phase (m=0)

• secondary metabolites. Antibiotics.

Mixed - growth associated / Partially growth associated. takes place during growth and stationary phases.

• metabolic by-products. lactate, ethanol.

• secondary metabolites.

Garden’s Law of Product Formation.

Growth-associated Mixed-growth associated

Non-growth associated

Primary MetaboliteReleased as a result of metabolic processes which are essential for the life of the micro-organism e.g. ethanol from Saccharomyces cerevisiae. Thus, primary metabolites are produced throughout the growth of the micro-organism, especially through the exponential phase.

Secondary MetaboliteA substance which is not essential for the life of the micro-organisms and which is not produced as a result of the growth process e.g. penicillin.Secondary metabolites are produced after the exponential growth phase has stopped. This is important because it means that secondary metabolites such as penicillin cannot be produced in continuous fermenters – which deliberately maintain the micro-organism in the exponential growth stage.

Production of secondary metabolite starts when exponential growth stops and growth of cells starts to slow. Adding a lot of extra nutrients at time T (see graph) will simply increase the growth of the micro-organism but not formation of the product. However, by adding a small amount of extra nutrients at this time, the amount of product formed can be increased.