Machine Design I (MCE-C 203) - Fayoumfayoum.edu.eg/stfsys/stfFiles//243//2378//07) Machine... ·...

Machine Design I(MCE-C 203)

1

Mechatronics Dept.,

Faculty of Engineering,

Fayoum University

Dr. Ahmed Salah Abou Taleb

Lecturer, Mechanical Engineering Dept.,

Faculty of Engineering, Fayoum University

Course OutlinesDesign of detachable joints: ( threaded joints , keys and splines).

2

Keys Pins. Splines.

Introduction

3

How attach power transmission components to shaft to prevent rotation and axial motion?

Torque resistance: keys, splines, pins, weld, press fit, etc..

Axial positioning: retaining rings, locking collars, shoulders machined into shaft, etc….

Keys

4

• A key is the piece inserted in an axial direction between a shaft and hub of the mounted machine element such as pulley or gear etc., to prevent relative rotation….

• Keys are temporary fastening and are always made of mild steel because they are subjected to shearing and compressive stresses caused by the torque they transmit.

• a keyway is the groove cut in the shaft or hub to accommodate a key.

Keys

5

Keys Design

6

• keys are sunk in the shaft and the hub.

Let D = diameter of the shaft

- width of the key W = D/4

Rectangular cross-section

nominal thickness H = (2/3)W = (1/6)D

Square cross-section:

nominal thickness H = W = D/4

Keys Design

7

Step 1 – Determine key size based on shaft diameter.

Step 2 – Calculate required length, L, based on torque.

Shear stress

Bearing stress

Required Length based on Shear Stress:

NSywhereDW

TL d

d

/5.02

Required Length based on Bearing Stress:

NSywhereDH

TL d

d

/4

N = 3

T = F*(D/2) or F = T/(D/2) this is the force the key must react!!!

Keys Design

8

Keys Design

9

Splines

10

“Axial keys” machined into a shaft

Transmit torque from shaft to another machine element

Advantages:

•Can carry higher torque for given diameter (vs keys).

•Lower stress on attachment (gear)

•Better fit, less vibration (spline integral to shaft so no vibrating)

•May allow axial motion while reacting torque

Disadvantage:

•Cost

•Impractical to use as fuse

Splines Design

11

Torque capacity is based bearing stress on the sides of the splines

T = 1000*N*R*h

N = number of splines

R = mean radius of the splines

h = depth of the splines )dD(2

1h

4

dD

2

dD

2

1R

8

dDN1000

2

dD

4

dDN1000T

22

Splines Design

12

A: Permanent Fit

B: Slide without Load

C: Slide under Load

Splines Design

13

T = kD2L

T = torque capacity

kD2 = torque capacity per unit length (from Table 11-5)

L = length of spline in inches

Splines Design

14

Splines Design

15