View
7
Download
0
Category
Preview:
Citation preview
Hydrothermal Synthesis Reactor Unit Zeolites and Microporous Crystals
HIRO COMPANY
Specifications• Maximum Pressure : 3MPa • Maximum Temperature : 200℃ • Principal Material : SUS304, PTFE • Reactor Vessel Volume : 50ml, 100ml, 150ml, 200ml, 300ml • Number of Reaction Vessels：4 (expandable to 12)
• Mixer Variable Rotation Speed : Standard Parts 0~50rpm
Our product (Hydrothermal Synthesis Reactor Unit) was developed in 1993 for the purpose of making the synthesis reaction of Zeolites and Microporous.
Main Features1)Our stirring system of Reactor Unit is an agitating type
by rotating the reaction vessels which shall be installed in a heating device.
2)It is superior in the uniformity of the temperature inside during the synthesis reaction and in the detachment of the contents.
3)It is possible to perform multiple testing material using different of contents at one time (2 – 12 kinds of materials).
Hence, that is good for comparison experiment.
4)Easy to operate.
ReactorSetting Bolt
Stainless Steel Cap
Stainless Steel Sheet
Teflon Sheet
Teflon O-ring
Teflon Inner Vessel
Stainless Steel Vessel
Use and Operating InstructionsNo.1
■ ■ ■■ ■ ■■ ■ ■■ ■■ ■
Sample materials
Stainless Steel Vessel
Teflon Inner Vessel
Sample materials
Set 「Teflon O-ring」
Set 「Teflon Sheet」
Set 「Stainless Steel Sheet」
Set 「Stainless Steel Cap」
Screw the Stainless Steel Cap securely
Stainless Steel Vessel
No.3No.2
Teflon O-ring
Teflon Sheet
Stainless Steel Sheet Stainless SteelCap
Tighten the 6 Setting Bolts evenly with a torque Wrench.
After setting up the reactor vessel, attach the set reactor vessel to the rotary drive shaft in the heater unit.
No.5No.4
Setting Bolt
Turn on the switch on the right side of the heater unit, set the temperature (Note A, Program Settings) and set it to ON to begin the heating cycle.
Turn on the rotary drive and adjust the RPM speed. Normally, the speed should be 15～20rpm.
No.7No.6
Completion of Zeolites
That’s all
Recommended