Group 21 Lubrication Charts and Specifications

21-

LUBRICATION SPECIFICATIONS-ITEM FORO PART NO.

C4AZ-19584-AR-138-B

B7AZ-19542-AR-IO3-A

CIAZ-195£O-B

PART NAME

Lifetime Body GreaseBody Hinges

FORO SPECIFICATIONS

ESB-MICIO5-A

Brake Master Cylinder Rotunda Heavy DutyBrake Fluid SAE 70R3

MIC75-AFoMoCo Ball Joint GreaseFront Suspension Ball Jointsand Steering Linkage

Front Wheel Bearings

Hood latch & Safety Catch

C2AZ-19585-A

C4AZ-19584-AR-138-B

B4A-19587-A

CIAZ-19580-E or F

ESA-MIC60-A

ESB-MICIO5-A

FoMoCo Wheel Bearing Grease

Lifetime Body Grease

lock Cylinders

Rear Axle (except 390 CID 2Vand 4V)

Rear Axle (Hi PerformanceEngines and 390 CID 2V and 4V)

limited Slip Axles (use 4 Ol.of additive per axle)

Steering Gear Housing (Manualor Power)

Steering.Power(Pump Reservoir)

Convertible Top Reservoir

ESB-M2C20-A

ESW-M2C50-A

Rotunda Lock Lubricant

FoMoCo Hypoid Gear Lube

C2AZ-19580-D FoMoCo Hypoid Gear lube ESW-M2C57-A

CIAA-19B546-A locking Differential Additive ESW-M2C58-A

C3AZ-19578-A Lifetime Steering Gear Grease ESW-MIC87-A

M2C33-D

M2C33-D

Transmission (Automatic) M2C33-D

CIAZ-19582-AR-IO6-A

CIAZ-19582-AR-IO6-A

Cl~Z-19582-AR-IO6A

C3RZ-19C547-B

CIAZ-19586-B

ESW-M2C83-A

ESA-MIC57-A

Transmission (Manual Shift)

Universal Joints

Engi ne Crankcase OilSAE lOW-20W-30

SAE 5W-IOW-20

SAE 20W-30-40

Rotunda AutomaticTransmission Fluid

Rotunda AutomaticTransmission Fluid

Rotunda AutomaticTransmission Fluid

Rotunda Manual Transmission Lube

FoMoCo Universal Lube

Rotunda Motor Oil (MS Sequence testedSAE lOW-20W-30 above-lOaF SAE5W-lOW-20 for substained temperaturesbelow -lOaF SAE 20W-30-40 fortemperatures above +90°F)

C5AZ-19579-A, B or CR-IO-A, B or CC5AZ-19579-D, Eor FR-IO-D, E or FC5AZ-19579-G, H or JR-IO-G, H or J

ESE-M2CIOI-A

Engine Oil Filter CIAZ-6731-ARI-A

Rotunda Oil Filter-6,OOO mile type

If it is necessary to use an "MS"oil which is not certified by the mar-keter as having passed the EngineOperating Sequence Tests, the ad-dition of Rotunda Oil Conditionerto the oil will satisfy the requirements.Rotunda 6,000 Mile Motor Oilmeets these requirements.

ENGINE CRANKCASE OILS

Use of SAE IOW-30 oil will pro-vide the proper viscosity for all nor-mal ranges of outside temperatures.For operation at sustained outsidetemperatures below -100 F. a 5W-20 oil should be used.

Oil Quality

Use only oils which have beentested and certified by the maker assatisfying automobile manufacturersspecifications for Engine OperatingSequence Tests for Service M.S.The Ford Motor Company specifi-cation covering these tests is ESEM2CIOI-A. These tests are defined

Oil Filter

Use of the right oil filter is alsoessential to good engine life and op-eration. For 6,OOO-mile filter changeintervals, filters must meet FordSpecification ES-COAE-6714-A.

The Genuine Rotunda Oil Filtermeets this requirement.

by ASTM committee D2 for SectionG-IV of technical committee Bandare published in the SAE Handbook.

These tests cover oil characteristicsas follows:Sequence I-Low Temperature WearPrevention-(Cold Starts)Sequence II-High-Speed-High Tem-perature Wear Prevention.Sequence III-High Temperature De-posit Formation-(Varnish)Sequence IV -Corrosion and RustPreventionSequence V-Sludge Formation

If engine oils are used which donot meet these requirements, it willbe necessary to change oil morefrequently than every 6,000 miles.

GROUP 2121-2 LUBRICATION CHART

. COOLING SYSTEM DRAIN

I

BRAKE LINESAND LINING

A FRONT SUSPENSION

Yl005-B

FIG. 1 . Typical Lubrication Chart-6-Cylinder EnQine

GROUP 21- LUBRICATION CHART 21-3

. COOLING SYSTEM DRAIN

fRONT WHF~L BEARINGS

TRANSMISSION BANDS(AUT()MATIC)REACH

UPPER

~\I - - I TRANSMISSION

I I (MANUAL)

.BRAKE LINESAND LINING

REAR AXLE

A FRONT SUSPENSION

Yl004.~

FIG. 2-Typical Lubrication Chart-V-8 Engine