GNSS observation file monitoring for RABTpnac.swisstopo.admin.ch/resplt/rabt_r2.pdf ·...

GNSS observation file monitoring for RABTDate/Time: Sat Nov 30 07:12:45 2019 UTCLast RINEX file: RABT3330.19D.ZRINEX version: 2.11Marker: RABT 35001M002Receiver: JAVAD TRE_3 DELTA 3.7.6Antenna: TRM29659.00 SCIS

Epochs

- "UseEp": The usable epoch is introduced if four or more satellites are observed with the minimum of two frequencies.- Cycle slip detection algorithm is based on Melbourne-Wübbena and geometry-free LC.

Satellites

Bands

Federal Office of Topography swisstopo RABT 35001M002

Sat Nov 30 07:12:45 2019 UTC 1/6

Observations

Multipath

Federal Office of Topography swisstopo RABT 35001M002

Sat Nov 30 07:12:45 2019 UTC 2/6

Federal Office of Topography swisstopo RABT 35001M002

Sat Nov 30 07:12:45 2019 UTC 3/6

- The multipath is estimated as a standard deviation over a sequence of consecutive epochs.

Signal-to-noise ratio

Federal Office of Topography swisstopo RABT 35001M002

Sat Nov 30 07:12:45 2019 UTC 4/6

Estimates

2019-11-29 00:00:00 GPS 5255617.6288 -631745.2984 3546322.6446 33.998104810 353.145714799 90.0666 2019-11-29 00:00:00 GLO 5255615.8596 -631746.2658 3546322.4833 33.998111878 353.145702117 88.6158 2019-11-29 00:00:00 GAL 5255617.2623 -631745.2530 3546322.7567 33.998107510 353.145714814 89.8232

BNC

Federal Office of Topography swisstopo RABT 35001M002

Sat Nov 30 07:12:45 2019 UTC 5/6

Equipment

2019-10-31 00:00:00 JAVAD TRE_3 DELTA 3.7.6 02334 TRM29659.00 SCIS 0220148021

Program info

G-Nut/Anubis [2.2.4] compiled: Mar 4 2019 19:39:07 ($Rev: 2554 $) BNC 2.13.0 (checkout 8149)

Federal Office of Topography swisstopo RABT 35001M002

Sat Nov 30 07:12:45 2019 UTC 6/6