EENG-491-M03 Watchmen Final Report of Auto-Parking System Members: DaHe Wen, Adam YiRan Huang,...

EENG-491-M03 Watchmen Final Report of

Auto-Parking System

Members: DaHe Wen, Adam YiRan Huang, Crissh QiuLu Shen, Logan

Introduction

Auto-parking system is a system that can help people to park their cars by remote control. As we all known ,with the development of science and technology, cars are becoming more and more common in our daily life. It becomes more and more difficult to park cars, so it is necessary to work out a system that can help people to park cars.

Here are some terrible parking jobs:

THIS SYSTEM CAN BE USED IN MANY SITUATIONS WHEN YOU WANT TO PARK. BECAUSE IT HAS NOT BEEN SPREAD OUT, SO IT HAS A LOT OF PROFITS IN THE FUTURE

Potential Market

That is why we want to design an auto-parking system to solve this problem! If we have this auto-parking system, we can get rid of these awful situation above!

1. HANDLE THE SIGNAL OF PARKING SENSOR 2. SIMULATE NORMAL IN COMPUTER 3. CONNECT THE CIRCUIT SUCCESSFUL 4. CONTROL THE MODEL WELL

Expectation

THEN WE WILL SHOW YOU A IDEAL DEMO

THE FIRST IS ABOUT THE HARDWARE, WE CAN USE MODEL TO SIMULATE. THE MOST IMPORTANT PART IS THE SELECTION OF SENSOR CHIP AND MODEL.

Process

The standard of parking sensor:1.Should have the reversing radar display, audible alarm, regional alerts and location instructions

2.The detection range should between 0.3m to 1.5m

3. The cost should not be too expensive

FINALLY WE CHOOSE PYLE’S PRODUCT-----WATCHDOG

THEN WE WENT TO THE LAB TO TEST THE CHIP:

the instruction of the parking sensor:

WE HAVE TO DO THREE TESTS:

1.The warning distance test

2.The obstacle location display test

3.The detection dead angle test

AFTER THAT THREE TESTS,

WE FIND THE SENSOR IS GOOD

THEN WE WILL SELECT MODELS

AT FIRST WE WANT TO GET TOY CARS

THEN WE FIND TWO PROBLEMS

1. There is no place to set up sensors

2. Can not change the direction obviously

THUS WE CHANGE TO USE ROBOT

AFTER THE TRANSFORMATION:

THE SECOND IS SIMULATING THE PROCESS OF THE AUTO-PARKING SYSTEM. THIS IS ALSO QUITE AN IMPORTANT PART OF THIS PROJECT!

The first condition: the perpendicular parking

WE SHOULD USE APPLET TO DO THE SIMULATION

The formula is

The second condition: the parallel parking

THE THIRD IS DESIGNING THE CONTROL SYSTEM OF THE AUTO-PARKING SYSTEM. THIS IS THE CORE PART OF THIS PROJECT!

WHAT WE WANT TO REALIZE IS

1.Get the signal of parking sensor

2. Understand how the computer get the feedback

3. When should the robot rotate

WE HAVE MEASURED THAT

The signals of parking sensor are

divided into two situations

WHEN THE DISTANCE IS BIGGER THAN 0.3M

WHEN THE DISTANCE IS SMALLER THAN 0.3M

SO WE NEED AMPLIFIER TO MAGNIFY THE CURRENT

BECAUSE WE NEED TO SWITCH THE CIRCUIT, SO THE ELECTROMAGNETRELAY IS ALSO NEEDED.

THEN WE CAN GRAPH THE CIRCUIT

WE PUT IT INTO REALITY

then the system will get the feedback and calculation

NEXT THE SYSTEM WILL GIVE THE COMMAND TO CIRCUIT AND LET IT ROTATE

HERE IS OUR EXPERIMENT DEMO

REALISTIC CONSTRAINTS

Because the response time from the sensor is so long, so we have failed many times, the sensor is not in good use as we thought. But our budget is limited, so we can not get a more sensitive sensor.

BECAUSE IT IS JUST A TEST EXPERIMENT, SO THERE ARE LOTS OF PROBLEMS EXISTING: THE VOLTAGE IS UNSTABLE, THE WIRE CONNECTION IS BROKEN, THE SIGNAL OF REMOTE CONTROL IS BLOCKED, ETC. WE HAVE FAILED MANY TIMES, BUT SOMETIMES WE STILL FIND THAT THE ROBOT CAN DO THE ROTATION WHEN IT GETS CLOSE TO OBSTACLES. THAT PROVED WE CAN USE THE SENSOR’S SIGNALS AND GIVE COMMANDS TO THE ROBOT.

Conclusion

IF YOU WANT TO KNOW MORE, PLEASE TAKE A FOCUS ON OUR WEBSITE:

HTTP://IRIS.NYIT.EDU/~YHUANG21/

THANK FOR YOUR PATIENT!

Appendix :•Integral steering linkage formula

•Disconnect style steering linkage symmetrical formula

•Disconnect style steering linkage of non-symmetric formula