View
247
Download
5
Category
Tags:
Preview:
Citation preview
DMX Controller SB-DN-512DMX
to Ethernet hub
512ch DMX scene controller
Computer lighting Moving heads Moving heads
to other DMX fixtures
DMX bus
Wiring
Wiring Diagram
3ch 650mA LED driver
connect to other DMX fixture
10-30VDC
DMX bus
DMX bus
DMX status LED
HDL Buspro
Wiring Diagram
Set the DMX start channel
Start channel(range001-512):e.g., If you use screw driver to set the start channel as 004, then the rest two channels will be ch5 & ch6, so R channel=4, G channel=5, B channel=6.
Special function: mainly for testing whether the device works or not
513 channel B ON514 light G ON515 light R ON516 lights R&G&B ON
3CH 650mA LED Driver
04/21/23
There is a LCD panel and some keys on this module, you can manually check or change the IP via them.
Whenever the IP is changed, the module is needed to be reset. (press the four keys at the same time for several
seconds.) e.g., set the IP as 192.168.10.122, then reset it, after that, change the IP of the laptop as
192.168.10.123 and ping 192.168.10.122, see if it can be pinged successfully.
IP Setting
subnet ID and device ID
Device remark
Generally no need to set it if just DMX512/1990(if use Art-Net or HDL-NET, need to set these parameters.)
Change the ID if needed
Basic Information
Current area
Channels of current area
Area
Area remark
Save
Area Remark
Select an area
Create new area
Channels waiting to be assigned. Add channels to and delete
channels from current area
Channels in current area
Area Setup
Effect property - CANCELED
Make sure that Lower limit ≤ Higher limit ≤ Max limit, setting range: 0% - 100%
Mapping relationship between “HDL channel” and “DMX channel”
Channel remark
Channel
Select Area
Fill in a range to be involved
Scene remark
Scene
Running time: the transit time till the scene reaches the preset brightness.
Mix the levels of channels to create scene
save
Useful option when creating a scene.
Scene Setup
Add sequence
Add Sequence
Current sequenceSteps (scenes) of current sequence
Sequence
Set sequence mode
Set running timesStep (scene) Qty
save
Sequence Setup
Assign a scene to each step
Set running time of each step
save
Sequence Setup
Channel Control
Set 'single on/off' mode, and input the DMX 512 ID(1/104), control type is 'single channel lighting control', parameter1 is for channel number(1-4), paremeter2 is for brightness(0-100).
use button 1 to control channel 1 of DMX512:
Scene Controluse button 2 to control scene 1 of DMX512:
Set 'single on/off' mode, and input the DMX512 ID(1/104), control type is 'sc
ene', parameter1 is for area number, paremeter2 is for scene number.
Sequence Control
Set 'single on/off' mode, and input the DMX512 ID(1/104), control type is 'sequence', parameter1 is for area number, paremeter2 is for sequence number.
use button 3 to control sequence 1 of DMX512:
Recommended