View
2
Download
0
Category
Preview:
Citation preview
DIY ROCK ‘N’ ROLL HINGES TECH SHEET
NB. Please note that whilst every attempt is made to ensure that these instructions are as clear as possible, we cannot be held responsible for misinterpretation of these instructions or for any subsequent accident or damage caused through mis-fitted parts. 0845 1204582 www.justkampers.com
• In the seatingposition
• In the bedposition
Use the measurements shown for thecorrect fitting of your hinges. makesure that measurement ‘A’ allows forthe seat back to be rolled into the bedposition.
The sized drawings are given as astarting guide. There are manyvariations in the way the hinge set canbe installed to suit the intended usage.
Instructions for positioning your rock n roll bed hinges
Front ofvehicle
Note: These measurementsare for a guide only but canbe altered to suit yourparticular application.
Rear Floor
Support
28mm
120mm
216mmA
50mm
Seat Panel
FrontPanel
SidePanel
SidePanel
SidePanel
Seat Back
bedplansrandr1randr2randr3
Recommended