ADSP-BF533 EZ-Kit Lite (Summit ICE Connection) Installation in ICT320

ADSP-BF533 EZ-Kit ADSP-BF533 EZ-Kit Lite (Summit ICE Lite (Summit ICE

Connection) Connection) Installation in Installation in

ICT320ICT320

Pre-InstallationPre-Installation

Connect the ADSP-BF533 board to Connect the ADSP-BF533 board to the PC using the 14-pin JTAG cable the PC using the 14-pin JTAG cable (do not force, notice that pin 3 is (do not force, notice that pin 3 is missing on the board)missing on the board)

Power up the board by connecting Power up the board by connecting the AC adapterthe AC adapter

Remember the ADSP-BF533 is a 16-Remember the ADSP-BF533 is a 16-bit processor, make sure to use bit processor, make sure to use VisualDSP++ for 16-bit processorsVisualDSP++ for 16-bit processors

Start VisualDSP++Configurator

VisualDSP++ Configurator Window

Select ADSP-BF533 EZ-KIT Lite via Summit (for ENCM 415 Labs) and press Copy...

Leave settings at default, press OK (base address should default to 0x7830)

Selected platform should be on the right hand pane, press OK

Testing the Testing the ConnectionConnection

Start ICETest Utility

Make sure Summit-ICE is selected as the Type, then press Start

ICETest Passed (green checkmarks for all items under status). Click Exit

Starting Starting VisualDSP++ for VisualDSP++ for

the first timethe first time

Start VisualDSP++ EnvironmentIMPORTANT NOTE:Hold Down Control (CTRL) on the keyboard

Select Blackfin Emulators/EZ-KITs under Debug Target, then select the platform you just created. Change the Session name if needed, then press OK

VisualDSP++ started. If there is an error box, check all connections

and try again.