Additional Transmitter for the Wizard Remote Blaster

Product Code: Barcode:

BPWRCE1/G600284400 4507

How it works

www.ellies.co.za

Control your TV equipment in your TV room fromyour bedroom.

REMOTE WORLD

Interference free

Plug-in receiver and emitter eyes for use with concealed equipment

MultiChoice compatible

Ideal for plasma and LCD

Additional Transmitter for theWizard Remote Blaster

TAPPROVEDA/508/2000

1 x Add-on transmitter unit. (Requires existing Wizard Remote Blaster to function)1 x Plug-in infrared Receiver eye (For use with concealed Transmitter)

THE PACKAGE CONTAIN

Technical information

Specifications:

WARRANTY

1YEAR

DIGITALRECEPTION

220-240V / 50Hz AC Mains power Buit-in surge & spike protection. Infra-red to RF transmitter 433.92MHz Compatible with most remote controls.

BEDROOM 1

BEDROOM 2

TV ROOM

Use emittereyes withconcealed

AV equipment.

RemoteBlastercan beconcealed

Product Code: Barcode:

BPWRCE1/G600284400 4507REMOTE WORLD

Additional Transmitter for theWizard Remote Blaster

www.ellies.co.za

Add-on Transmitter

The Receiver of your existing Wizard Remote Blaster system should be used as the “MASTER RECEIVER”. This “Add-on Transmitter” must be taught the “MASTER RECEIVER’S” ID code.

Quick Setup

1. Unplug and place both the Transmitter unit and Receiver unit on a flat surface so that the red windows are facing each other.2. Plug both units in at the same time. (Both units must be powered up within 2 seconds of each other.)3. After 5 seconds check to see of the red indicator light at the front of the Transmitter stays on permanently. This indicates that pairing has been completed successfully. If the indicator light is not on permanently, pairing has failed. Unplug both units, wait 10 seconds, and start again from step 1.

If pairing was successful, unplug the units and move them to the positions where you will be using them.

Copying Original Code (Pairing)

New“ADD-ON”

transmitter

Original“MASTER”receiver

Red window& light