A 3D Micromixer Fabrication With Dry Film Resist

A 3D Micromixer Fabrication With Dry Film Resist

Advisor ： Cheng-Hsien Liu Reporter ： Yu-Sheng LinDate ： 2007/04/18

A.D. Radadia1, L. Cao1, H.K. Jeong1, M.A. Shannon2, R.I. Masel1

1Department of Chemical and Biomolecular Engineering, 2Department of Mechanical Science and Engineering, University of Illinois at Urbana-Champaign, USA MEMS 2007 pp.361~364

PME5230 2

Outline

IntroductionFabricationMicro-mixer designResultsConclusions

PME5230 3

Introduction DFR ： Dry Film Resist

PME5230 4

Fabrication

PME5230 5

Micro-mixer Design6 layers

PME5230 6

PME5230 7

Compare of wet etching and RIE

PME5230 8

Results

PME5230 9

Microscopic images of (a) 4 patterned layers

(b) 6 patterned layers and a cap layer

Microscopic images during process

PME5230 10

Conclusions

A technique utilizing by dry film resist to build 3D microstructures with 6 layers patterned has been developed.Dry film resist is available in bio-compatible format.Future work will focus on building MEMS devices for biosensing applications.

PME5230 11

Thank you for your attention !

PME5230 12

Woodpile structure

3 layers

PME5230 13

Ref: M.S. Munson, P. Yager, Analytica Chimica ACTA, 2003 pp.63~71