View
218
Download
0
Category
Preview:
Citation preview
i220-411 www.powercommander.com 2005-2007 Kawasaki VN1600N - PCIII USB - 1
2005-2007 Kawasaki 1600 NomadInstallation Instructions
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
Parts List1 Power Commander1 USB Cable1 CD-ROM1 Installation Guide1 Power Adapter2 Power Commander Decals2 Dynojet Decals2 Velcro® Strip1 Alcohol Swab
You can also download the PowerCommander software and latest mapsfrom our web site at:
www.powercommander.com
The ignition MUST be turnedOFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Button Adjustment Display
Faceplate Buttons
USB PortExpansion Port
1 Remove the main seat and thepassenger seat.
2 Remove the fuel tank
Note: The installation can be donewithout removing the fuel tankbut it may be easier to have itremoved
3 To remove the fuel line squeezethe sides of the connector (Fig. A). Disconnect the twoelectrical connectors.
4 Loosen the four bolts holding onthe left hand side cover (Fig. B).
5 Route the PCIII harness betweenthe tray and the frame (Fig. C).
Fig.
AFi
g. B
Fig.
C
i220-411 www.powercommander.com 2005-2007 Kawasaki VN1600N - PCIII USB - 2
Disconnect these lines
Loosen these bolts
PCIII harness
6 Continue routing the PCIII har-ness towards the front of thebike. Route underneath theframe and towards the left handside of the rear cylinder(Fig. D).
7 Continue routing the PCIII har-ness along the frame towards thefront of the bike. Locate thestock connector for the throttlebodies (Fig. E).
8 Unplug this connector.
9 Plug the connectors from thePCIII in-line of the stock con-nector (Fig. F).
Fig.
DFi
g. E
Fig
F
i220-411 www.powercommander.com 2005-2007 Kawasaki VN1600N - PCIII USB - 3
Unplug this connector
PCIII harness
Stock connectors
PCIII connectors
10 Attach the ground wire from thePCIII to the negative side of thebattery (Fig G).
11 Install the PCIII under the lefthand side cover (Fig. H).
NOTE:
If you have a California model itis best to velcro the unit to thefront portion of the charcoalcanister (Fig J). Use the sup-plied velcro to attach the unit.
Fig.
GFi
g. H
i220-411 www.powercommander.com 2005-2007 Kawasaki VN1600N - PCIII USB - 4
PCIII ground wire
Fig.
J
Recommended