Simply measure 2 2011012021

Simply Measure 2

A pictorial guide

Empty Sheet Ready to start

Just Click a module button. We will click the Cube Module to make the Cube Module appear in the first free position.

The Cube dims are yellow and the word cube has appeared. This is the default module heading

Dims added to first line brings up total volume. Note deducts in red, no need to enter minus value. Any value in deducts column is taken off.

Two lines filled in on cube module note extra line created. Text type in S Cell replaces “Cube” as module title. Notice title typed in Cell P2 appears in header

Square Module only has length and width cells highlighted. only part view shown

Note rough work calculations in cells under module title. Notice the Sets value is multiplied by the area. If sets value left out 1 set is used.

Note add Number/ Weight module button clicked, brought up decision box 1=Number, 2=Kilogram, 3=Tonne and 4 = Item

Tonne Module added by typing 3 in the decision box on previous slide. Weights entered notice rate omitted causes error warning.

Clicked the close modules button to close up to compact Bill of Quantities format. Button caption now says “ Open Modules”

Note Linear Module is open while the rest of the sheet is closed. This makes it easy to scan over previous work.

Conclusion

This slideshow is intended to illustrate the simplicity of Simply Measure.

• It is not comprehensive.• The system has more facilities than we have demonstrated.• John Wakefield Smith will guide any new user if needed.• The system can be enhanced to suit users needs.• Use the free Trial Download.• You can even complete a commercial measure on the free trial.• You can print Bill of Quantities or detailed costing from the trial.• When you buy the key your trial becomes the fully functioning version.• You can create a copy for each project.• They must be in the same folder as the key• If you are not impressed feel free to say so in my guest book.