N1 presentation1

Presents a series of

Affordable Zero Energy Homes

Homes with no utility bill that can also power a plug-in

hybrid car

How it started: a friend of my mother’s bought into a subdivision. We visited it. I thought, how to

design solar homes for all these lots?

Upon Reflection, it occurred to me that if we could design houses for the 8 points on the

compass that we could then cookie-cutter in any subdivision. A name and a Logo ensued:

A potential investor suggested we consider putting together a Homeplans Catalog. We started

researching existing home plans and worked up an executive summary:

We researched home plans , homes we had built, solar homes we knew of, zero energy homes,

and visited with local architects. What we found was:

• A lot of “Green Washing” –homes with on demand hot water heaters, low-E glass, sometimes some solar thermal, etc.

• Old school solar/direct gain homes-not energy efficient in colder climates-too much heat loss at night

• “Material Zealots” : SIPS panel houses, various ICF systems, straw-bale, machined log, etc.

• Some valid homes, each with merit, but generally very custom and expensive

• The “Tight Box” approach with some Photovoltaics but no sunspace

• Geothermal /ground source heat pump systems-expensive and of questionable durability

One Home we did like, was that of a fellow local contractor who has remained an on going consultant. We felt the solar thermal was too

complex and that the design could have been better integrated, but it was Zero Energy-quite a feat in

our climate.

One feature we liked was the isolated sunspace, which was narrow and more of a

collector than your classical lounge chair sunspace. The heat was circulated through the house using in-

line duct Panasonic Whisperline Fans.

We also talked to NREL. We consulted with their Residential Division, about the insulation

package for a house we were doing. They recommended a system that yielded an R-33 wall

with standard materials and methods, close to SIPS at half the cost and equal or greater than an ICF

wall.

We found no non- cardinal point designs. They intrigued us, so with a local

architecture firm we worked up some conceptual designs - some for actual lots in the original

subdivision.

Some Architects said they could modify their homes to be Zero Energy Homes, but none manifested any designs. It became clear:

It was time to design a house ourselves.

From our gathered research the house would need:

• The NREL insulation package• An isolated Sunspace Collector on the south side• An ample south facing roof for a large PV array

• Thermal Inertia Mass for heat retention• An integrated Heating and Distribution System

• Zero maintenance-so we eliminated Solar Thermal• High Performance Windows and Doors

• An attractive and integrated design

On a camping trip, by the fire one night, the Vision came:

In that vision all essential components were embodied. A cost effective Building System was revealed:

A Key component was the Hybrid Truss. It gives the house a large south facing roof for a

large photovoltaic array and an inexpensive second story space due to its prefabricated modular

construction.

Attic space

Habitable Attic

roughly 50% of

main floor SF

Photovoltaic Array

With Hybrid Homes architect Vern Seieroe, we embarked upon design of a prototype home. We realized the truss had

many variations, which we had engineered. Its pitch could also vary.

“Max” Truss allows a maximum PV array

Hybrid Truss with return-a more classical

roof look

Dormer Truss allows south windows with a

Craftsman look

“Long Truss” for houses with Sunspace

on the side

Our design was essentially a modified ranch home with a south side sunspace collector

and an upstairs generated by the Hybrid Truss.

We embellished the entry side with a craftsman style porch and dubbed the house

the N1, for north side entry version1

We obtained a Photovoltaic Bid. The design could accommodate a 24 KW system. With federal rebates and in Xcel electric territory, the

cost of this system would be approximately $39,000, with a payback estimated at 11 years.

Note that ∆ is the difference between the Standard Home and the Home after the column.

∆ ∆ ∆

Cost to Own versus Cost to Buy: this Cost Analysis Chart compares a Standard Home with three levels of a Hybrid Home. The stronger the rebates the greater the economic advantage of a Hybrid Home.

The Economic Advantage is even greater with a longer term loan. Note the advantage in Xcel territory where even at today’s heating cost it makes sense to

install the large PV system

We drew up NREL’S insulation scheme that involved simple framing and

readily available products and methods:

We had this design energy modeled by George Scott and Associates. The results were

impressive. The house with the sunspace and the insulation already achieved a HERS rating of 55.

Adding the PV Array, the HERS rating dropped to -55 !

For those unfamiliar with a HERS rating:

• HERS stands for Home Energy Rating System. A house built to today’s code standards achieves a rating of 100.

• The sample design shown here achieves a rating of

-55 which is to say it powers itself and could provide half the power for another house.

The Design even exceeded our initial expectations:

A True and Affordable Zero Carbon Footprint Home*

Possible due to Unique and Integrated Design Features:• 24 Kw Grid Tie PV system• Sunspace Heat Collector• Integrated Heating and Distribution System• Thermal Inertia Mass• Six Sided Super Insulated Building Envelope• High Performance Windows and Doors• Low Cost Construction due to the use of the Hybrid

Truss* (patent pending) and standard framing techniques

• Energy Engineered, HERS -55• Green Finishes = Healthy Interior and Sustainable

Products

*below Net Zero over a year = net energy producer

. Plus, according to our engineer, the design generates enough energy to heat and run the house as well as power a plug-in hybrid car like the

Nissan Leaf or Chevy Volt = NO GASOLINE BILL

In my mind one problem remained: how to transfer the heat from the ceiling of the sunspace

to the thermal mass floor. We called this the Liquid Heat Transfer System. Conceptually it

looks like this (orange line):

From a database of a sunspace collector, we know that the temperature at the ceiling generally exceeds 130 degrees on sunny

days:

Our own calculations indicated an average gain of 244,000 BTU per day averaged for January-

March:

After investigating various assemblies and products, and in consultation with NREL,

we came up with a simple design that incorporated a fin tube into the air circulating system. The liquid would then be circulated into the concrete floors,

We sourced a Heating Engineer , recommended by a fin tube manufacturer. Given

the previously stated conditions, he calculated that 25,000 BTU/hr would be transferred. Over a typical 6 hr solar gain period, that would result in 150,000

BTU’s transferred to the main floor slab or a temperature gain of approximately 4 degrees for 10

tons of concrete.

We modified the Heat transfer Diagram to include the Liquid Heat Transfer

System:

Liquid

We filed a Patent Application for the Hybrid truss and the Liquid Heat

Transfer System.

No Cooling would typically be required. The photovoltaic array shades the south roof and the overhang of the sunspace blocks the summer sun. Additionally the east and west windows of the sunspace could be opened for ventilation. Also the house windows could be opened at night to cool

the concrete thermal mass floors down to nighttime temperatures.

We realized that many Ranch Home Plans could be modified to a Hybrid

Home, by adding a Sunspace Collector and the Hybrid Truss.

Classical Ranch Floorplan

“Hybidized” with Sunspace and Hybrid

Truss second story space

These houses could be small like the conversion of this 560SF ranch home, which, as configured, could be a duplex. We would love to

build this for Habitat for Humanity:

560SF, 1 & 1/2 bedroom ranch

Becomes a 1200SF two story Hybrid Home

We looked at many suitable properties and collected many standard ranch plans that could be modified. Scaling

everything to 1/8” and cutting the plans out, we could readily find a plan for any property with

suitable solar access.

Some standard plans cut to 1/8” scale

Shown below is one of those plans dropped onto Lot 24 at Shadow Grass Estates in Longmont,

CO:

The new Production Home of the future could be a slab on grade Ranch with an unfinished attic as opposed to the old

ranch with an unfinished basement

Fancier 3 bedroom ranch floor plan

Adding a Sunspace to the side and the Hybrid

Truss gives an attic space of approx. 880 SF

And Jeffrey’s best graphic mock-up of the front elevation for the previous

house:

Home Plans Rendering Modifying the roof with the Hybrid “Long Truss”.

Entry etc. need architectural detailing

(e.g.next slide)

Vern did better on a property that we liked. We developed a full schematic design

for 1325 S. Kimbark in Longmont, CO:

The Main Floor was compact and versatile with a main floor flex room with its own

entrance:

The second floor has a nice master suite and a second bedroom:

We envisioned an unfinished basement for future growth:

Mechanical room

We worked up pricing. Realizing that our database was for custom homes, we consulted with

local builders to fine tune our estimate:

We put together a proforma and talked to banks. We found that we would need investors to

leverage the project.

Having had the vision of a novel product and developed it, we let go of the

idea of a Home Plans Catalog. Instead we are focused on finding a property for a Demonstration

Home aka Proof of Product. Our realtor is preparing an ad to source a presold home.

Our current objective :

How about a world of self-sufficient homes, no energy bill and enough surplus to power a plug-in hybrid car’s daily commute. How about a country of self sufficient structures. How about an alternatively powered America that is no longer dependent on foreign oil and unstable political whims.

With the recent advent of significant rebates, mass production of photovoltaic panels, advances in insulation techniques, and home energy research the ultimate solar house has finally become possible and affordable.

The time has come for a Phoenix to arise from the ashes of the home building industry Join us in this exciting venture

Presents a series of

Affordable Zero Energy Homes

Homes with no utility bill that can also power a plug-in

hybrid car