View
2.688
Download
1
Category
Preview:
DESCRIPTION
Information on the 2012 Toyota Highlander Blue Tooth.For more information please visit www.jerrystoyota.com
Citation preview
347
3
Interior features
3-3. Using the Bluetooth® audio system
Bluetooth® audio system∗
■Conditions under which the system will not operate● If using a portable player that does not support Bluetooth®
● If the portable player is switched off
● If the portable player is not connected
● If the portable player’s battery is low
● If the portable player is behind the seat or in the glove box or console box
● If metal is covering or touching the portable player
The Bluetooth® audio system enables you to enjoy music played ona portable digital audio player (portable player) from the vehiclespeakers via wireless communication.
This audio system supports Bluetooth®, a wireless data systemcapable of playing portable audio music without cables. If your por-table player does not support Bluetooth®, the Bluetooth® audio sys-tem will not function.
Owners of models equipped with a navigation system should refer tothe “Navigation System Owner's Manual”.
Title Page
Using the Bluetooth® audio system P. 350
Operating a Bluetooth® enabled portable player P. 355
Setting up a Bluetooth® enabled portable player P. 357
Bluetooth® audio system setup P. 362
∗: If equipped
348
3-3. Using the Bluetooth® audio system
■When transferring ownership of the vehicleBe sure to initialize the system to prevent personal data from being improp-erly accessed. (→P. 387)
■About Bluetooth®
■Compatible models●Bluetooth® specifications:
Ver. 1.2
●Following Profiles:
• A2DP (Advanced Audio Distribution Profile) Ver. 1.0• AVRCP (Audio/Video Remote Control Profile) Ver. 1.0 or higher (Ver.
1.3 or higher recommended)Portable players must correspond to the above specifications in order to beconnected to the Bluetooth® audio system. However, please note that somefunctions may be limited depending on the type of portable player.
■Certification for the Bluetooth® audio systemFCC ID: ACJ932C5ZZZ035IC ID: 216J-C5ZZZ035MADE IN JAPAN
This device complies with Part 15 of the FCC Rules and RSS-Gen of ICRules. Operation is subject to the following two conditions: (1) this devicemay not cause harmful interference, and (2) this device must accept anyinterference received, including interference that may cause undesired oper-ation.
Bluetooth is a registered trademark ofBluetooth SIG. Inc.
349
3-3. Using the Bluetooth® audio system
3
Interior features
CAUTION
■FCC WARNINGChanges or modifications not expressly approved by the party responsiblefor compliance could void the user's authority to operate the equipment.
Radio Frequency Radiation Exposure. This equipment complies with FCC/IC radiation exposure limits set forth for uncontrolled equipment and meetsthe FCC radio frequency (RF) Exposure Guidelines in Supplement C toOET65 and RSS-102 of the IC radio frequency (RF) Exposure rules. Thisequipment has very low levels of RF energy that it deemed to comply with-out maximum permissive exposure evaluation (MPE). But it is desirable thatit should be installed and operated with at least 7.9 in. (20 cm) and morebetween the radiator and person’s body (excluding extremities: hands,wrists, feet and ankles).
This transmitter must not be co-located or operated in conjunction with anyother antenna or transmitter.
■Caution while drivingDo not connect portable players or operate the controls.
NOTICE
■To prevent damage to portable playersDo not leave portable players in the vehicle. The temperature inside thevehicle may become high, resulting in damage to the player.
350
3-3. Using the Bluetooth® audio system
Using the Bluetooth® audio system
■ Audio unitDisplay Track title, Artist name,Album name, Elapsed time,“Streaming Audio”, etc. isdisplayed.Selects items such as menuand numberTurn: Selects an itemPress: Inputs the selecteditemBluetooth-Audio connec-tion condition
If “BT” is not displayed, theBluetooth® audio systemcannot be used.
■ Microphone
351
3-3. Using the Bluetooth® audio system
3
Interior features
Operating the system using voice commands
By following voice guidance instructions output from the speaker,voice commands enable the operation of the Bluetooth® audio sys-
tem without the need to check the display or operate .
■ Operation procedure when using voice commandsPress the talk switch and follow voice guidance instructions.
■ Auxiliary commands when using voice commandsThe following auxiliary commands can be used when operating thesystem using a voice command:
“Cancel”: Exits the Bluetooth® audio setup“Repeat”: Repeats the previous voice guidance instruction“Go back”: Returns to the previous procedure“Help”: Reads aloud the function summary if a help comment isregistered for the selected function
352
3-3. Using the Bluetooth® audio system
Using the Bluetooth® audio system for the first time
Before using the Bluetooth® audio system, it is necessary to registera Bluetooth® enabled portable player in the system. Follow the proce-dure below to register (pair) a portable player:
Press and hold until “BT AUDIO” is displayed.
Press (SETUP).
The introductory guidance and portable player name registrationinstructions are heard.
Select “Pair Audio Players (Pair audio player)” using a voice
command or .
Register a portable player name by either of the followingmethods:
a. Select “Record Name” using , and say the name to
be registered.b. Press the talk switch and say the name to be registered.
A voice guidance instruction to confirm the input is heard.
Select “Confirm” using a voice command or .
A passkey is displayed and heard, and a voice guidance instructionfor inputting the passkey into the portable player is heard.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
353
3-3. Using the Bluetooth® audio system
3
Interior features
Input the passkey into the portable player.Refer to the manual that comes with the portable player for the oper-ation of the portable player.
Guidance for registration completion is heard.
If the portable player has a Bluetooth® phone, the phone can be reg-istered at the same time. (→P. 370)
Menu list of the Bluetooth® audio system
“BT Audio Setup” can be canceled by pressing the on-hook switch orsaying the voice command, “Cancel”.
First menu Second menu Third menu Operation details
Setup (Setup)
BT Audio Setup (BT audio setup)
Pair Audio Players (Pair audio player)
Registering a portable player
Select Audio Player
Selecting a portable player to be used
Change Name Changing the registered name of a portable player
List Audio Players
Listing the registered porta-ble players
Set Passkey Changing the passkey
Delete Audio Player
Deleting a registered porta-ble player
System Setup
Guidance Vol-ume
Setting voice guidance vol-ume
Device Name Displaying the Bluetooth® device address and name
Reset Setting Initializing the system
STEP 6
354
3-3. Using the Bluetooth® audio system
■When using a voice commandFor numbers, say a combination of single digits from zero to nine.
Say the command correctly and clearly.
■Situations where the system may not recognize your voice●When driving on rough roads
●When driving at high speeds
●When air is blowing out of the vents onto the microphone
●When the air conditioning fan emits a loud noise
■Operations that cannot be performed while driving
●Operating the system with
●Registering a portable player to the system
■Changing the passkey→P. 360
355
3-3. Using the Bluetooth® audio system
3
Interior features
Operating a Bluetooth® enabled portable player
Selecting an album
Press “∨” or “∧” on .
Selecting tracks
Press “∧” or “∨” on .
Playing and pausing tracks
Press .
VolumePower
Playback/pause
Displaying text messages
Selector knob
Selecting tracksFast-forwardingand reversing
Playback
356
3-3. Using the Bluetooth® audio system
Fast-forwarding and reversing tracks
Press and hold “∧” or “∨” on .
Switching the display
Press .
Each time is pressed, the display changes in the following order: Track title → Track title/Artist name → Track title/Album name → Tracktitle/Elapsed time
Using the steering wheel audio switches
→P. 341
■Bluetooth® audio system functionsDepending on the portable player that is connected to the system, certainfunctions may not be available.
357
3-3. Using the Bluetooth® audio system
3
Interior features
Setting up a Bluetooth® enabled portable player
Registering a portable player in the Bluetooth® audio system allowsthe system to function. The following functions can be used for reg-istered portable players:
■ Functions and operation procedures
Press and hold until “BT AUDIO” is displayed.
Press (SETUP).
Select one of the following functions using a voice com-
mand or .
● Registering a portable player “Pair Audio Players (Pair audio player)”
● Selecting a portable player to be used “Select Audio Player”
● Changing the registered name of a portable player“Change Name”
● Listing the registered portable players “List Audio Players”
● Changing the passkey “Set Passkey”
● Deleting a registered portable player “Delete Audio Player”
STEP 1
STEP 2
STEP 3
358
3-3. Using the Bluetooth® audio system
Registering a portable player
Select “Pair Audio Players (Pair audio player)” using a voice com-
mand or , and perform the procedure for registering a portable
player. (→P. 352)
Selecting a portable player to be used
Select “Select Audio Player” using a voice command or
.
Select the portable player to be used by either of the followingmethods, and select “Confirm” using a voice command or
:
a. Press the talk switch and say the name of the desired por-table player.
b. Press the talk switch and say “List audio players”. When thename of the desired portable player is read aloud, press thetalk switch.
STEP 1
STEP 2
359
3-3. Using the Bluetooth® audio system
3
Interior features
Press the talk switch and say “From car” or “From audio”, and
select “Confirm” using a voice command or .
Vehicles with smart key system: If “From car” is selected, the porta-ble player will be automatically connected whenever the “ENGINESTART STOP” switch is in either ACCESSORY or IGNITION ONmode.
Vehicles without smart key system: If “From car” is selected, the por-table player will be automatically connected whenever the engineswitch is in either the “ACC” or “ON” position.
Changing the registered name of a portable player
Select “Change Name” using a voice command or .
Select the name of the portable player to be changed byeither of the following methods, and select “Confirm” using a
voice command or :
a. Press the talk switch and say the name of the desired por-table player.
b. Press the talk switch and say “List audio players”. When thename of the desired portable player is read aloud, press thetalk switch.
Press the talk switch or select “Record Name” using ,
and say the new name.
Select “Confirm” using a voice command or .
STEP 3
STEP 1
STEP 2
STEP 3
STEP 4
360
3-3. Using the Bluetooth® audio system
Listing the registered portable players
Select “List Audio Players” using a voice command or . The
list of registered portable players will be read aloud.When listing is complete, the system returns to “BT Audio Setup”.
Pressing the talk switch while the name of a portable player is beingread aloud selects the portable player, and the following functions willbecome available:
● Selecting a portable player: “Select Audio Player”
● Changing a registered name: “Change Name”
● Deleting a portable player: “Delete Audio Player”
Changing the passkey
Select “Set Passkey” using a voice command or .
Press the talk switch, say a 4 to 8-digit number, and select
“Confirm” using a voice command or .
When the entire number to be registered as a passkey has
been input, press again.
STEP 1
STEP 2
STEP 3
361
3-3. Using the Bluetooth® audio system
3
Interior features
Deleting a registered portable player
Select “Delete Audio Player” using a voice command or
.
Select the portable player to be deleted by either of the follow-ing methods and select “Confirm” using a voice command or
:
a. Press the talk switch and say the name of the desired por-table player.
b. Press the talk switch and say “List audio players”. When thename of the desired portable player is read aloud, press thetalk switch.
If the portable player to be deleted is paired as a Bluetooth® phone,the registration of the mobile phone can be deleted at the same time.A voice guidance instruction to delete a mobile phone is heard.
Select “Confirm” using a voice command or .
■The number of portable players that can be registeredUp to 2 portable players can be registered in the system.
STEP 1
STEP 2
STEP 3
362
3-3. Using the Bluetooth® audio system
Bluetooth® audio system setup
■ System setup items and operation procedures→P. 385
Recommended